Pioneer DVJ-X1 - Professional DVD Turntable Навчальний посібник - Сторінка 26

Переглянути онлайн або завантажити pdf Навчальний посібник для DVD-плеєр Pioneer DVJ-X1 - Professional DVD Turntable. Pioneer DVJ-X1 - Professional DVD Turntable 38 сторінок. Dvd video deck

Друкувати сторінку

3. Serial control terminals

• The serial control terminals for checking the ID number and the player section are provided inside the rear panel

(hidden inside the slit of the rear panel) and inside the main unit (6-pin connector).

• To use the terminals, a PC with an RS-232C serial communications terminal, and either of the special device for level

conversion dedicated for the hidden connector inside the slit of the rear panel or a special device for downloading, such

as the CDJ-1000, are required.

• Do NOT use both terminals simultaneously, because these terminals are internally connected.

The terminal is hidden inside the slit.

COMPOSITE

NORMAL

MODE

DIGITAL

AUDIO OUT

VIDEO OUT

OUT

SYNC IN

CONTROL

PREVIEW OUT

4. How to input the ID number

• If error E-7016 is displayed, the ID number must be input.

• For inputting the ID number, a PC with an RS-232C serial communications terminal, the special device for level

conversion, and the ID data disc (a special DVD disc on which the ID-number data) are written are required.

This product is a player, please use a disc for recorder as ID data disc.

Procedures

1 Check the ID number. The 9-digit ID number is written on the label attached to the bottom of the main unit.

2 Connect the RS-232C terminal of the PC and the DVJ-X1 using a special device. (See next page.)

• When the special device for level conversion is used, connect the card cable to the hidden connector inside the slit of

the rear panel.

• When a special device for downloading, such as the CDJ-1000, is used, open the bottom plate of the main unit to

reveal the 6-pin connector and connect the special device with the connector.

• As the hidden connector inside the rear panel and the 6-pin connector inside the main unit are internally connected,

they must not be connected simultaneously.

3 Start up the terminal software of the PC (communication speed: 4800 bps, parity: none, STOP bit: 1).

4 Turn on the power of the DVJ-X1.

If error E-7016 is displayed, press the ENTER key on the PC several times to confirm that "R" is returned.

5 Enter "2MC" to confirm that "R" is returned. Use uppercase alphabetics for input.

6 Enter the 9-digit ID code then "ID" and confirm that "R" is returned.

If you type a wrong number for the ID code, type the correct numbers again.

7 Load the special DVD disc into the player.

Wait for the unit to start up then enter "IW" to confirm that "R" is returned.

If error E11 is returned, wait a few moments then enter "IW" again.

8 Enter "EJ" to eject the disc, then turn off the power of the DVJ-X1 then turn it back on. Check that no error is displayed.

ID number label

CN102

6-pin connector