Pioneer S-1EX Інструкція з експлуатації Посібник з експлуатації - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Акустична система Pioneer S-1EX. Pioneer S-1EX 28 сторінок. Ex series
Також для Pioneer S-1EX: Брошура та технічні характеристики (16 сторінок), Посібник з експлуатації (12 сторінок)

Друкувати сторінку

Pioneer S-1EX Інструкція з експлуатації Посібник з експлуатації

• Screw two picture hooks or similar into the wall behind

the speaker. Pass a chain or cord around the hooks and

through the metal catch so that the speaker is stabilized

(make sure to test that it supports the weight of the

speaker).

Metal catch

• After installing, make sure the speaker is securely fixed.

• For good sound, the speaker should be about 20 cm

away from the back wall and at least 50 cm away from

the side wall. If the room has a lot of reverberation, we

recommend hanging heavy fabric on the walls, and/or

putting a carpet on the floor to damp the sound. For best

results, cover walls completely.

20 cm

50 cm

• Place speakers equal distances from your listening

position for good stereo sound. Use speaker cords of the

same length for each speaker.

• If you are using a set of speakers for your TV sound,

install the speakers at equal distances either side of the

TV and point them in the same direction as the TV.

• Do not place the speaker where it will be in direct

sunlight, and avoid positioning it near heaters and air

conditioners. This may cause warping and discoloration

of the speaker cabinet and damage the speaker.

• Pioneer assumes no liability whatsoever for damages

resulting from assembly, improper mounting, insuffi-

cient reinforcement, misuse of the product, acts of

nature, etc.

Using the spikes

There are four metal spikes built-in to the speaker base that

you can use to isolate the speaker from the floor. Spikes are

recommended when placing the speakers on a thick carpet

(for added stability), or for better sound when placing the

speakers on a hard reverberant surface (such as a concrete

or wood floor). Use the supplied spike pads to avoid scratch-

ing the floor or other surface where the speaker is placed.

Choose the location for speaker placement then put

the spike bases on the floor.

Remove the protective cover from the top of the leg

support.

Protective covers

Place the speaker upright so that the corners are

resting on the spike bases on the floor.

Insert and turn the supplied hex wrench until the

spike protrudes from the base.

Do this in turn for each spike, making sure all four corners

are of even height and the speaker is stable and resting

squarely on all four spikes.

After the spike lengths are even, tighten the nuts to

fix the spikes in place.

Caution: when using the spikes

• Note that these spikes are sharp metal and can cause

damage to flooring. Make sure to lay down a cloth or

suitable base before setting up.

• The speaker is very heavy (about 66 kg) and can cause

serious damage or injury if you are attempting to tighten

the nuts with the speaker standing or leaning. Make

sure to lay down a cloth and tighten the nuts with the

speaker laying flat. Two people or more during place-

ment and setup is advised.

Hex wrench