Ariston WMTF 703 H HK Інструкція та посібник з монтажу - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція та посібник з монтажу для Пральна машина Ariston WMTF 703 H HK. Ariston WMTF 703 H HK 16 сторінок. Top loading washer

Друкувати сторінку

Ariston WMTF 703 H HK Інструкція та посібник з монтажу

使用本機須知

BEFORE USING THE WASHING MACHINE

拆除包裝

Remove the packaging and check

Cut and remove the shrink-wrap.

Remove the top protection and the protective corners.

Remove the bottom protection by tilting and turning the

washing machine on one rear bottom corner.

After unpacking, make sure that the washing machine is

undamaged. If in doubt, do not use the washing machine.

Contact After-Sales Service or your local retailer.

Keep the packaging material (plastic bags, polystyrene

parts, etc.) out of reach of children; they are potentially

dangerous.

If the appliance was exposed to the cold prior to delivery,

keep it at room temperature for a few hours before

operating.

拆除保護裝置

Remove the transport bracket

The washing machine is fitted with transport screws and a

transport bracket to prevent damage during transport.

Before using the washing machine you must remove the

transport bracket (see p3 Installation).

安放洗衣機

Install the washing machine

Place the washing machine on a flat and stable floor

surface.

Adjust the feet to ensure that the machine is stable and

level.

40x60

In case of wooden or so-called floating floors (for instance

certain parquet or laminate floors), place the appliance on

a sheet of plywood with a size of at least 40 x 60cm and

thickness of at least 3cm, which is screwed to the floor.

Make sure that the ventilation openings in the base of your

washing machine (if available on your model) are not

obstructed by a carpet or other material.

(

)

Water supply

供供供供水水水水

Tap: 3/4" threaded hose connection.

Water supply: Cold water only

100-1000 kPA (1-10 bar)

Pressure: 100-1000 kPA (1-10 bar).

Only use new hoses for connecting the washing machine

to the water supply. Used hoses must not be used

anymore and should be discarded.

Drain hose

排水排水排水排水

Firmly connect the drain hose to the siphon for drain water.

If the washing machine is connected to a built-in drainage

system, ensure the latter is equipped with a vent to avoid

simultaneous loading and draining of water (siphoning

effect)

6. 電源連接

電源連接 Electrical connection

電源連接

將電插頭連接入牆上電源插座前，，，，請作以下檢查

將電插頭連接入牆上電源插座前

Before plugging the appliance into the electricity socket,

make sure that:

The socket is earthed and in complies with the applicable

laws.

The socket is able to withstand the maximum power load

of the appliance as indicated in the Technical date table

(on the right).

The socket is compatible with the plug of the washing

machine. If this is not the case, replace the socket or the

plug.

The technical data (voltage, power and fuses) are given

on the rating plate on the rear of the washing machine.

When the washing machine has been installed, the

electricity socket must be within easy reach.

Do not use extension cord or multiple sockets.

The cable should not be bent or compressed.

The power supply cable must only be replaced by

authorized technicians.

The washing machine must be connected exclusively by

means of a socket with an earth connection, in compliance

with the regulations in force. In particular, washing

machines installed in premises containing a shower or a

bath must be protected by a differential residual current

device of at least 30mA. Earthing the washing machine is

obligatory under the law. The manufacturer declines all

liability for injury to persons or animals or damage to

property deriving either directly or indirectly from failure to

observe the directions in these Instructions for Use.

製造商對違反安全條例所造成的後果概不負責

製造商對違反安全條例所造成的後果概不負責。。。。

製造商對違反安全條例所造成的後果概不負責

Warning! The company shall not be held responsible in

the event that these regulations are not respected.

3/4

。

請作以下檢查︰︰︰︰

請作以下檢查