Dinel CLS-23 Інструкція з експлуатації - Сторінка 10

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Аксесуари Dinel CLS-23. Dinel CLS-23 18 сторінок. Capacitive level sesors
Також для Dinel CLS-23: Посібник (20 сторінок)

Друкувати сторінку

8 . s

ensor settings

The setting is done by placing magnetic pen  to sensitive

spot  located on the front of the sensor. hort time attaching

up to  sec. of the magnetic pen to the sensitive spot 

maes the sensor open. ong time attaching at least  sec. of

the pen when the level is changed denes closed state of the

sensor. n this way is set the sensitivity for the measured medi-

um and switching modes  normally open or  normally

closed.

ensors of type CLS 23E are produced without signaling indicator LED. or control of correct

settings it is necessary to interconnect the sensor to related evaluation unit or load.

n the case of the vertical mounting for detection of non-conductive liuids by sensors CLS 23_ 20;

30 and for detection of conductive and non-conductive liuids by sensors CLS 23_ 21 it neces-

sary to set limits  and  when electrode of the sensor is immersed to medium.

mode O

normally open

mode C

normally close

ACTOR

AULT S TTIN S

Types CLS 23_ 10; 20; 30 are set to detect mineral oil CLS 23_ 11; 12; 21 to detect water.

The mode  is set sensor closes when immersed.

9 . s

tatUs signalization

ndicator

range 

 Dinel

CLS 23

hen the level is low the container is empty attach the magnetic pen

 to the sensitive spot  for short time ma.  sec.. hen the

level is high the container is full attach the magnetic pen  to the

sensitive spot  for long time min.  sec..

hen the level is low the container is empty attach the magnetic pen

 to the sensitive spot  for long time min.  sec.. hen the level

is high the container is full attach the magnetic pen  to the sensitive

spot  for short time ma.  sec...

(only with LED state indicator variant)

unction

Continuous light  ensor is closed switched 

Dark  ensor is open switched 

Rapid ashing (period 0.2 s)  nrecognied upper and lower limits or setting mistae

Slow ashing (period 0.8 s)  hort circuit at sensor output

Sensitive spot