Dinel CPS-24N Інструкція з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Перемикач Dinel CPS-24N. Dinel CPS-24N 14 сторінок. Capacitive proximity switch

Hose clip

Fig. 6: protective PVC hose

5 . Electrical connection

Sensor with NPN or PNP output is allowed to lead only by resistive or inductive lead. Positive sup-

ply voltage (+U) is connected to the brown conductor BN (1), negative (0 V) to the blue conductor

BU (3) and the leads (only NPN or PNP type of output) to the black conductor BK (4). The capacity

loads and low resistance loads (bulb) is evaluated by the sensor as short circuit.

The line from CPS-24N to the connecting device is from a suitable three wire (min. 3x0.5 mm2)

cable, in the case of variant CPS-24Xi using a two wire (min. 2x0.5 mm2) cable. In the event that

a disassemblable socket ELWIKA or ELKA 4012 K PG7 are used, the max. outer diameter of the

cable is 6 mm. Connector socket is not part of the sensor.

Fig. 7: NPN type sensors connection

Fig. 9: PNP type sensors connection

Legend:

(*) – Numbers of terminals inside of the connector

BK – Black

BN – Brown

BU – Blue

Electrical connection can only be made when de-energized!

The source of the power voltage must comprise of a stabilised safe low power source with

galvanic separation. In the event that a switch-mode power supply is used, it is essential

that its construction effectively suppresses common mode interference on the secondary

side. In the event that the switch-mode power supply is equipped with a PE safety terminal,

it must be unconditionally grounded! Spark-safe devices (type CPS-24) must be powered

from a spark-safe power source meeting the above-mentioned requirements.

CPS–24

Protective hose

Cable

(version "N")

(version "P")

In the case of vertical mounting in outer areas or in the

case of high mechanical exertion we recommend to in-

stall in Variant "B" protective hose on the cable (see

figure).

Fig. 8: NAMUR type sensors connection

Fig. 10: Inside of the connector socket

(version "Xi")

Output (BK)

+U (BN)

0V (BU)