Ariston ANDRIS2 B 15 O Інструкція по встановленню, використанню, обслуговуванню - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція по встановленню, використанню, обслуговуванню для Водонагрівач Ariston ANDRIS2 B 15 O. Ariston ANDRIS2 B 15 O 36 сторінок.
Друкувати сторінку
GENERAL SAFETY INSTRUCTIONS
1. Read the instructions and warning in this manual carefully,
they contain important information regarding safe installa-
tion, use and maintenance.
This manual is an integral part of the product. Hand it on to
the next user/owner in case of change of property.
2. The manufacturer shall not liable for any injury to people, ani-
mals or damage to property caused by improper, incorrect or
unreasonable use or failure to follow the instructions reported
in this publication.
3. Installation and maintenance must be performed by profes-
sionally qualified personnel as specified in the relative para-
graphs. Only use original spare parts. Failure to observe the
above instructions can compromise the safety of the appliance
and relieves the manufacturer of any liability for the conse-
quences.
4. DO NOT leave the packaging materials (staples, plastic bags,
expanded polystyrene, etc.) within the reach of children - they
can cause serious injury.
5. The appliance may not be used by persons under 8 years of
age, with reduced physical, sensory or mental capacity, or
lacking the requisite experience and familiarity, unless under
supervision or following instruction in the safe use of the appli-
ance and the hazards attendant on such use. DO NOT permit
children to play with the appliance. User cleaning and mainte-
nance may not be done by unsupervised children.
6. DO NOT touch the appliance when barefoot or if any part of
your body is wet.
7. Before using the device and after routine or extraordinary main-
tenance, we recommend filling the appliance's tank with water
and draining it completely to remove any residual impurities.
8. If the appliance is equipped with a power cord, the latter may
only be replaced by an authorised service centre or professional
technician.
9. It is mandatory to screw on the water inlet pipe of the unit a
safety valve in accordance with national regulations. In coun-
tries which have enacted EN 1487, the safety group must be
calibrated to a maximum pressure of 1487 MPa (0,7 bar) and
include at least a cock, check valve and control, safety valve
and hydraulic load cutout.
EN
9