Aeotec TriSensor Посібник користувача - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник користувача для Аксесуари Aeotec TriSensor. Aeotec TriSensor 18 сторінок.

29-1-2019

If you're using an existing gateway (ie. Vera, Smartthings, ISY994i ZW, Fibaro, etc):

You may need to refer to your gateway's method of including devices if you do not know how to pair a Z-Wave

device. You may use any gateway to perform an unpair/removal on TriSensor even if they are not paired together to

factory reset TriSensor.

1. Put your primary Z-Wave gateway into unpair mode, your Z-Wave gateway should confirm that it is waiting to

remove a device

2. Press the Action Button on your TriSensor 3x times within 2 seconds. The LED on TriSensor will become a solid

purple color.

3. If your TriSensor has been successfully removed from your network, the LED will flash white, green, white, green

(white, then green 2x times).

Advanced configurations for TriSensor.

You may also view our engineering sheet for TriSensor here:

https://aeotec.freshdesk.com/helpdesk/attachments/6064224662

(https://aeotec.freshdesk.com/helpdesk/attachments/6064224662)

Monitoring motion.

When TriSensor detects a motion event it will automatically send a notification report to Group 1 which is usually

automatically set to report to your gateway upon pairing your TriSensor.

Command Class

Command

Type

Event

By default, your sensor will time out after 240 seconds, for better use as a presence sensor, you can retrigger the

motion sensor to reset its timeout back to 240 seconds after 30 seconds. These settings are configurable.

1. Motion re-trigger time.

This configures the delay time before you can retrigger the PIR sensor, if the re-trigger happens between retrigger

time and clear time, this will reset the clear time clock. If this is disabled, you must wait until motion clears to trigger

motion again.

This setting is used as a presence sense and works together with Parameter 2. This will also help with conserving

battery report as if you re-trigger before clear time ends, TriSensor will not send a report.

Parameter #

Size

DEFAULT SETTING = 30

https://aeotec.freshdesk.com/support/solutions/articles/6000195459-trisensor-user-guide-

COMMAND_CLASS_NOTIFICATION

NOTIFICATION_REPORT

HOME_SECURITY (0x07)

HOME_SECURITY_MOTION_DETECTION_UNKNOWN_LOCATION (0x08) /

HOME_SECURITY_NO_EVENT (0x00)

Value

1-32767

TriSensor user guide. : Aeotec

Description

Disable Motion Re-Trigger.

Delay time in seconds.

10/18