Dingo Tools 52CC Посібник користувача - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник користувача для Фреза для щіток Dingo Tools 52CC. Dingo Tools 52CC 11 сторінок. Duo power plus
Також для Dingo Tools 52CC: Посібник користувача (16 сторінок)
Друкувати сторінкуADJUSTING IDLE SCREW ON YOUR MACHINE
If your Idling of your brushcutter needs adjusting e.g it is idling too fast or slow or is cutting out please follow the steps below on
how to adjust this on your machine.
When looking down in a birds eye view at the carby or Choke area, at the the top of the Carby where the throttle control cable
attaches to the side of the mechanism, you will see a silver screw on the right hand side at the top.
Where the Sliver Screw enters in and the tip of the Silver Screw comes out the outer side, you should be able to view when looking
at least 3 – 4mm of screw tip, turning this screw to the left will speed up the idle, while turning the silver screw to the right will slow
the idle down.
We suggest that you adjust the screw so you may be able to view 3 or 4mm of screw tip, if you see more screw tip, please back
adjust the screw to this suggested setting and if you are viewing less of the screw tip, please adjust the screw so you are able to
view more of the tip at least 3 or 4mm of screw tip and no more or less.
FUEL MIXTURE SCREW ADJUSTMENT
If your machine is not revving or not running correctly
please adjust the Fuel Mixture Screw with the steps
to the right.
When facing the Carby side of the machine and looking at
the carby on the right hand side of the Carby down near the
top of the fuel tank and infront of the black fuel line in take
tube, you will see a brass screw, this is the fuel mix screw,
this adjusts how much fuel may enter the machine.
To set this screw in the correct position we need to start the screw at zero fi rst, please turn the brass screw all the way to the right
or clock wise until it will not turn any further, please try not to over turn it when screwing it all the way in, as when you have reached
the end of it's thread and if you keep turning it with force, you may snap the screw off.
When you have turned the screw all the way in to the right or clock wise so it can not turn any further this is what we call or state
as being at zero. Now please turn the screw 1 and 1 quarter turns to the left or anticlock wise to set it in the correct position for the
fuel intake and smooth operation.
*** NOTE ***
If 1 and 1 quarter turns isnt enough as the adjustment has not being successful please start the brass screw back at zero and try
a 1 and half full turns anti clock wise or to the left to set the carby with a little bit more fuel into the machine.
10