Ariston 41-116-06 Інструкція з монтажу Посібник з монтажу - Сторінка 18

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Котел Ariston 41-116-06. Ariston 41-116-06 48 сторінок. Microsystem

Друкувати сторінку

4.2

ONTROL

ANEL

EGEND

A - On/Off button

B - On/Off L.E.D. green (frost protection active)

C - Central Heating button

D - Cental Heating active L.E.D. green

E - Ignition failure (lockout) and/or overheat reset button

F - Ignition failure (lockout) and/or overheat L.E.D. red

G - Central heating temperature adjustment

H - Energy Saving System (ESS)

- Knock-out for time clock

J - Heating system pressure gauge

4.3

EMOVING THE

RONT

ANEL

When the installation and filling are completed turn on the central heating

system (section 4.4) and run it until the temperature has reached the boiler

operating temperature. The system must then be immediately flushed

through.

The flushing procedure must be in line with BS 7593:1992 code of practice for

treatment of water in domestic hot water central heating systems.

During this operation, we highly recommend the use of a central heating

flushing detergent (Fernox Superfloc or equivalent), whose function is to

dissolve any foreign matter that may be in the system.

Substances different from these could create serious problems to the

pump or other components.

The use of an inhibitor in the system such as Fernox MB-1 or equivalent is

strongly recommended to prevent corrosion (sludge) damaging the boiler and

system.

Failure to carry out this procedure may invalidate the appliance

warranty.

. 4.1

In order to access the inside of the boiler, it is necessary to

unscrew the fastening screws "A" of the control panel

located on the lower part of the panel itself.

The control panel moves downward and when pulled

forward rotates on two lateral hinges.

The panel stays in a semi-horizontal position, which allows

access to the inner parts of the boiler.

In order to increase the manoeuvring space, it is possible

to raise the control panel and rotate it to a fully horizontal

position.