Aeotec Smart Switch 6 Посібник - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник для Перемикач Aeotec Smart Switch 6. Aeotec Smart Switch 6 7 сторінок.
Також для Aeotec Smart Switch 6: Посібник користувача (12 сторінок)

Друкувати сторінку

network. This controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right

on the device.

Inclusion

Short press the product's Action button that you can find on the product"s housing.

Exclusion

Short press the product's Action button that you can find on the product"s housing.

Product Usage

Changing LED mode.

You can change the mode of how the LED acts through configuring Smart Switch. There are 3 different modes: Energy mode, Momentary

indicate mode, and Night Light mode.

Energy mode will allow the LED to follow the state of Smart Switch, when the switch is on, the LED will be on, and while the switch is off, the current colour

LED will be off and then remain the purple colour of 10% brightness. Momentary indicate mode will momentarily turn the LED on for 5 seconds then turn off

after every state change in the switch. Night light mode will allow the LED to be turned on and off during your selected time of day you have configured for

it.

Quick trouble shooting

Here are a few hints for network installation if things dont work as expected.

1. Make sure a device is in factory reset state before including. In doubt exclude before include.

2. If inclusion still fails, check if both devices use the same frequency.

3. Remove all dead devices from associations. Otherwise you will see severe delays.

4. Never use sleeping battery devices without a central controller.

5. Dont poll FLIRS devices.

6. Make sure to have enough mains powered device to benefit from the meshing

Firmware-Update over the Air

This device is capable of receiving a new firmware 'over the air'. The update function needs to be supported by the central controller. Once the controller

starts the update process, perform the following action to confirm the firmware update: In the case that you need to firmware update your Smart Switch 6,

please refer to this article here:

Association - one device controls an other device

Z-Wave devices control other Z-Wave devices. The relationship between one device controlling another device is called association. In order to control a

different device, the controlling device needs to maintain a list of devices that will receive controlling commands. These lists are called association groups

and they are always related to certain events (e.g. button pressed, sensor triggers, ...). In case the event happens all devices stored in the respective

association group will receive the same wireless command wireless command, typically a 'Basic Set' Command.

Association Groups:

Group Number

Configuration Parameters

Z-Wave products are supposed to work out of the box after inclusion, however certain configuration can adapt the function better to user needs or unlock

further enhanced features.

https://aeotec.freshdesk.com/solution/articles/6000134294-smart-switch-6-firmware-v1-03-update

Maximum

Description

Nodes

Group 1 is assigned to the Lifeline association group and every device has 5 nodes to

associate.When the switch is turned on or off using the action button, the switch will send a basic

report of its status to the nodes in association group 1. To change what kind of signal is sent to the

nodes in group 1, please see the detailed description of configuration parameter 80.

When the product receives a controlling Basic Set CC/Switch Binary Set CC, which if cause the

products load state to be changed, which will lead to send the Basic Set CC/Switch Binary Set CC to

nodes in group 2.