Aeotec ZW116 Посібник - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник для Перемикач Aeotec ZW116. Aeotec ZW116 13 сторінок. Single nano switch with measuring
Також для Aeotec ZW116: Посібник користувача (18 сторінок)
Друкувати сторінку
certified Z-Wave device regardless of brand and origin as long as both are suited for the same frequency
range.
If a device supports secure communication it will communicate with other devices secure as long as this device
provides the same or a higher level of security. Otherwise it will automatically turn into a lower level of security to
maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.
Product Description
Aeotec Nano Switch is a low-cost Z-Wave Switch specifically used to enable Z-Wave command and control
(on/off) of any wall switches. It can report immediate wattage consumption or kWh energy usage over a period
of time. In the event of power failure, non-volatile memory retains all programmed information relating to the
unit?s operating status.
It can connect to 2 external manual switches to control the load ON/OFF independently. Its surface has a pin
socket, which can be used for connecting to the touch panel, so you can also use the touch panel to control the
Nano Switch.
The Nano Switch is also a security Z-Wave device and supports Over The Air (OTA) feature for the products
firmware upgrade.
Prepare for Installation / Reset
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to
reset the device into factory default. You can do this by performing an Exclusion operation as described below in
the manual. Every Z-Wave controller is able to perform this operation however it is recommended to use the
primary controller of the previous network to make sure the very device is excluded properly from this network.
Reset to factory default
This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only
be used when the primary controller is inoperable.
Set Parameter 255
Safety Warning for Mains Powered Devices