Whirlpool 4GNTW4400 Інструкція з монтажу Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Пральна машина Whirlpool 4GNTW4400. Whirlpool 4GNTW4400 27 сторінок. Top-loading washer
Також для Whirlpool 4GNTW4400: Інструкція з монтажу Посібник з монтажу (27 сторінок), Інструкція з монтажу Посібник з монтажу (27 сторінок), Інструкція з використання та догляду (44 сторінок)

INSTALLATION INSTRUCTIONS

Before you start: remove shipping materials

It is necessary to remove all shipping materials for proper

operation and to avoid excessive noise from washer.

Move washer

48"

(1.2 m)

Move washer to within 4 ft (1.2 m) of its final location; it must

be in a fully upright position.

NOTE: To avoid floor damage, set washer onto cardboard

before moving it and make sure lid is taped shut.

Remove shipping base

To avoid damaging floor, place cardboard supports from

shipping carton on floor behind washer. Tip washer back, and

place on cardboard supports. Remove shipping base. Set

washer upright.

IMPORTANT: Removing shipping base is necessary for proper

operation. If your washer includes a sound shield, please refer

to the instructions included with the sound shield to install it at

this time.

Remove packing tray from tub

Remove tape from washer lid, open lid and remove cardboard

packing tray from tub. Be sure to remove all parts from tray.

NOTE: Keep tray in case you need to move washer later.

Free power cord

Firmly grasp power cord plug, and pull to free from rear panel.

Gently place power cord over console to allow free access

to back of washer.