Whirlpool 4GNTW4400 Інструкція з використання та догляду - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з використання та догляду для Пральна машина Whirlpool 4GNTW4400. Whirlpool 4GNTW4400 44 сторінки. Top-loading washer
Також для Whirlpool 4GNTW4400: Інструкція з монтажу Посібник з монтажу (27 сторінок), Інструкція з монтажу Посібник з монтажу (27 сторінок), Інструкція з монтажу Посібник з монтажу (27 сторінок)
Друкувати сторінку
WASHER
MAINTENANCE
WATER iNLET HOSES
Replace inlet hoses after 5 years of use to reduce the risk of
hose failure. Periodically inspect and replace inlet hoses if
bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement
on the label with a permanent marker.
WASHER
CARE
Recommendations
to Help Keep Your Washer
Clean
and Performing
at its Best
1. Always follow the detergent manufacturer's
instructions
regarding the amount of detergent to use. Never use
more than the recommended
amount because that may
increase the rate at which detergent and soil residue
accumulate
inside your washer, which in turn may result
in undesirable odor.
2. Use warm and hot wash water settings sometimes (not
exclusively cold water washes), because they do a better
job of controlling
the rate at which soils and detergent
accumulate.
3. Always leave the washer lid open between uses to help
dry out the washer and prevent the buildup of odor-
causing residue.
Cleaning
Your Top Loading
Washer
Read these instructions
completely before beginning the
routine cleaning processes recommended
below. This
Washer Maintenance Procedure should be performed,
at a minimum, once per month or every 30 wash cycles,
whichever occurs sooner, to control the rate at which soils
and detergent may otherwise accumulate in your washer.
Cleaning
the inside of the Washer
To keep your washer odor-free, follow the usage instructions
provided above, and use this recommended
monthly
cleaning procedure:
Recommended
Cycle for Cleaning
the Washer
Refer to the "Cycle Guide" for the optimal cycle for cleaning
the inside of the washer. Use this cycle with liquid chlorine
bleach as described below.
Begin procedure
1. Chlorine
Bleach Procedure:
ao Open the washer lid and remove any clothing
or items.
b. Add 236 mL (1 cup) of liquid chlorine bleach
to the bleach compartment.
NOTE: Use of more liquid chlorine bleach than is
recommended
above could cause washer damage
over time.
co Close the washer lid.
d. Do not add any detergent or other chemical
to the washer when following this procedure.
eo Select the cycle recommended
for cleaning the
inside of the washer.
fo Press the START/Pause/Unlock
Lid button to start
the cycle.
NOTE: For best results, do not interrupt cycle. If cycle
must be interrupted,
press START/Pause/Unlock
Lid
once or twice (depending on model). After the cycle has
stopped, run a RINSE / SPIN cycle to rinse cleaner from
washer.
F
WASHER
CARE (cont.)
"_
Cleaning
the Dispensers
After a period of using your washer, you may find some
residue buildup in the washer's dispensers. To remove
residue from the dispensers, wipe them with a damp cloth
and towel dry. Do not attempt to remove the dispensers or
trim for cleaning. The dispensers and trim are not removable.
If your model has a dispenser drawer, however, remove the
drawer and clean it before or after you run the Clean Washer
cycle. Use an all-purpose
surface cleaner, if needed.
Cleaning
the Outside
of the Washer
Use a soft, damp cloth or sponge to wipe away any spills.
Use only mild soaps or cleaners when cleaning external
washer surfaces.
iMPORTANT: To avoid damaging the washer's finish, do not
use abrasive products.
r
NON=USE AND VACATION
CARE
Operate your washer only when you are home. If moving, or
not using your washer for a period of time, follow these steps:
1. Unplug or disconnect
power to washer.
2. Turn off water supply to washer, to avoid flooding due
to water pressure surge.
f
WINTER
STORAGE
CARE
iMPORTANT: To avoid damage, install and store washer
where it will not freeze. Because some water may stay in
hoses, freezing can damage washer. If storing or moving
during freezing weather, winterize your washer.
To winterize
washer:
1. Shut off both water faucets; disconnect
and drain water
inlet hoses.
2. Put 1 L (1 qt.) of R.V.-type antifreeze in basket and run
washer on RINSE/SPIN cycle for about 30 seconds
to mix antifreeze and remaining water.
3. Unplug washer or disconnect
power.