Whirlpool 7MWFC5090KC Посібник з експлуатації та догляду та інструкція з монтажу - Сторінка 25
Переглянути онлайн або завантажити pdf Посібник з експлуатації та догляду та інструкція з монтажу для Пральна машина Whirlpool 7MWFC5090KC. Whirlpool 7MWFC5090KC 40 сторінок. Smart all-in-one washer and dryer
Друкувати сторінку
2.
Clear water line
Run water for a few seconds through hose into a laundry tub,
drainpipe, or bucket to avoid clogs. Water should run until
clear.
3.
Connect inlet hose to Washer/Dryer
Attach water hose to water inlet valve. Screw coupling by
hand until it is snug. Use pliers to tighten coupling an addi-
tional two-thirds turn.
IMPORTANT: To reduce risk of hose failure, replace the hose
every 5 years. Record hose installation or replacement dates
for future reference.
Periodically inspect and replace hose if bulges, kinks, cuts,
n
wear, or leaks are found.
4.
Check for leaks
Slowly turn on water faucet to check for leaks. A small amount
of water may enter washer/dryer. It will drain later.
5.
Secure drain hose
Laundry Tub
Standpipe
4,5"
4.5"
4,5"
(114 mm)
(114 mm)
(114 mm)
Secure drain hose to laundry tub leg, drain standpipe, or inlet hose
for wall standpipe with cable tie.
Level Washer/Dryer
IMPORTANT: Leveling your washer/dryer properly reduces ex-
cess noise and vibration.
1.
Check levelness of washer/dryer
Place level here
on either side
Remove cardboard from beneath washer/dryer. Place a level
on top edges of washer/dryer, checking each side and front.
If not level, tip washer/dryer and adjust feet up or down as
shown in Steps 3 and 4, repeating as necessary.
Not Level
Wall
4,5"
(114 mm)
(113 mm)
LEVEL
Not Level
4.5"
25