Whirlpool 7MWFC5090KC Посібник з експлуатації та догляду та інструкція з монтажу - Сторінка 31
Переглянути онлайн або завантажити pdf Посібник з експлуатації та догляду та інструкція з монтажу для Пральна машина Whirlpool 7MWFC5090KC. Whirlpool 7MWFC5090KC 40 сторінок. Smart all-in-one washer and dryer
MESSAGES ON THE DISPLAY
Your Washer/Dryer can display code messages on the display. Some codes indicate conditions of use that are not necessarily failures.
See table below. If the code still persists, check how to contact us at point 5 of the Warranty Certificate. Codes not described in the
table below indicate product failure. In this case, check how to contact us at point 5 of the Warranty Certificate.
Code
F0E2
F0E4
F0E5
F1E6
U4, F5E1 or F5E2
F8E1
F9E1
No code
F0E3, F1E2 to
F1E5, F3E1 to
F3E5, F4E1 to
F4E6, F5E1,
F5E3, F5E4,
F6E1 to F6E3,
F7E1 to F7E9,
F8E1 and F8E3
Presented
Excess detergent, lower the dosage.
Door locked, wait for the temperature
to low.
Unstable load, adjust clothes in the
basket.
Incorrect voltage, check socket.
Door is open. Please close the door.
There is no water, check the tap.
No water comes out, check the outlet
hose.
Transport screws detected.
Contact technical support.
On the display
Amount of detergent above
the recommended amount
for the product.
Internal temperature of the
product is high, the door is
locked for your safety.
The load of clothes is
not well distributed in
the basket, causing an
imbalance.
Your Washer/Dryer is
connected in a socket
that is not suitable for its
operation.
Your Washer/Dryer door
is open or not closed
properly.
Water shortage.
• Water outlet hose is
installed above 1.20 m.
• Folded water outlet
hose.
• Air inside the water
drainage system.
The transport screws have
not been removed.
Technical failure.
Description of probable
causes solution
Use the recommended for each
type of input (page 15).
• Powder detergent: Do not
exceed the indicated on the
measuring cup or 32 g of
the input, suitable for very
dirty clothes and maximum
washing capacity..
• Liquid detergent: Use a
maximum of 40 ml or
2 tablespoons of liquid
detergent.
Wait a few moments for
the door to unlock after the
temperature lows.
Distribute the clothes evenly in
the basket.
Check if the socket voltage is
compatible with the voltage of
your Washer/Dryer.
Make sure your Washer/Dryer
door is completely closed.
Make sure water is coming out
of the tap.
• Review the installation
information (page 8) and
reinstall considering the
appropriate hose height.
• Clear the hose.
• Clean the Buttons Catch
Compartment, as instructed
on page 17.
Remove the transport screws as
shown on page 6.
Enter the code when contacting
technical support.
31