Whirlpool 8MWTW2241 Інструкція з використання та догляду - Сторінка 29
Переглянути онлайн або завантажити pdf Інструкція з використання та догляду для Пральна машина Whirlpool 8MWTW2241. Whirlpool 8MWTW2241 41 сторінка.
Друкувати сторінку
In order to reduce the danger at the minimum for
possible electric shocks, the cable must be plugged in
a grounded 3 prong outlet, according to the local
codes and standards. If there is not available an
equivalent outlet, it is responsibility and obligation of
the costumer to have a proper plug with grounded
connection installed by a qualified electrician.
If codes allow it and the ground wire connection is
separated, it is recommended that a qualified
electrician determines if the grounded connection is
adequate.
If you are not sure the ground connection of the
washer is the proper one, verify it with a qualified
electrician.
NOTE: If the electric cable is damaged, it must be replaced by
an original electric wire and the replacement must be made by
an electrician.
INSTALLATION INSTRUCTIONS
Risk of Excessive Weight
Use two or more persons to move and
install the washer.
Failure in following these instructions
may cause back injuries or other kind of
injuries.
1.
Remove the package and take out the shipping base
Take out all shipping materials to get a proper function and
avoid excessive noise from the washer.
To avoid damages to the floor and washer, place the carton
corner protections on the floor, behind the washer. Lay the
washer down helped by another person and place it on the
carton corner protections (as shown). Remove the
transportation base. Put the washer in a vertical position.
IIMPORTANT: For a proper functioning it is needed to take out
the shipping base.
2.
Remove cardboard packing tray from tub
Remove tape from washer lid, open the lid and take out the
cardboard packing tray from tub and set aside. Assure all
packaging components were removed before installing the
washer.
NOTE: Keep the part in case you need to move the washer
later.
3.
Install the drain hose
6.1
6.2
.9m-1.2m
Fit the drain hose in the drainage according to the
installation.
6.1 Floor vertical pipe drain system
6.2 Wall vertical pipe drain system
6.3 Sink Drain system
For the above 3 types of installation, you must consider the
following issues:
Minimum diameter for vertical pipe draining: (5.1 cm)
Minimum draining capacity: 64 L per minute.
Hose must be placed to a height between 0.9 m and 1.2 m
from the floor. If it is placed at a lower height it may cause
the automatic drain.
IMPORTANT: There must not be more than 12 cm of draining
hose within the vertical pipe; do not force the excess of hose
within the vertical pipe, or place it in the sink bottom.
NOTE: Never remove bands located in the drain hose once
they are assembled in the washer rear panel, to avoid the
drain hose damage when using the cutting grippers. The
bands assembled in the rear panel, guarantee the correct
washer functioning.
4.
Install filling hoses
1
2
1
2
ATTACHMENT WITH FILTER
TOWARDS WATER OUTTAKE
Before connecting the hoses let the water run for 10
seconds.
Clean at least once a month the filters, removing the
hoses and use a brush to eliminate the residuals. Verify
for leaks.
6.3
.9m-1.2m
3
YOU MAY USE TWEEZERS
TO INSTALL HOSES.
29