Whirlpool AWO/D 9562 Посібник з монтажу - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник з монтажу для Пральна машина Whirlpool AWO/D 9562. Whirlpool AWO/D 9562 8 сторінок.
Друкувати сторінку
10600834.fm Page 6 Thursday, January 11, 2007 6:07 PM
Screw by hand the inlet hose onto the tap tightening the nut.
Attention:
• no kinks in the hose!
• The appliance must not be connected to the mixing tap of an un-pressurized
water heater.
• Check water-tightness of connections by turning the tap completely on.
• If the hose is too short, replace it with a suitable length of pressure resistant hose
(1000 kPa min, EN 50084 approved type).
• Check the inlet hose regularly for brittleness and cracks and replace if necessary.
• The washing machine can be connected without a non-return valve.
For models with Water Stop hose:
If the flexible hose is too short, replace it with a 3 m Water Stop hose (available from After-
Sales Service or from your dealer). This replacement is only to be carried out by a trained
electrician.
Depending on the model, the inlet hose and the plastic enclosure at the tap connection contain
electrical components. Do not cut the hose and do not immerse the plastic enclosure in
water. Isolate the appliance from the mains immediately if the hose is damaged.
10
(÷HUWDKOL\HKRUWXPXDúD÷ÕGDNLPRGHOOHUGHJ|VWHULOGL÷LJLELWDNÕOÕUVD
I.
+RUWXPXRNLOHLúDUHWOLNÕVNDoODUGDQoÕNDUWÕQÕ]
In case the drain hose is installed as shown on the models below:
Unclip it from the holders marked with arrows.
6
Black process 45.0° 130.0 LPI
7$+/ø<(+257808187$.,1,=