Whirlpool AWO6100P Посібник користувача - Сторінка 19
Переглянути онлайн або завантажити pdf Посібник користувача для Пральна машина Whirlpool AWO6100P. Whirlpool AWO6100P 20 сторінок. User manual
Друкувати сторінку
TROUBLESHOOTING
TROUBLESHOOTING
The following circumstances do not constitute problems. Do not contact the Service Center until the problem has been confirmed.
PROBLEM
Washing machine fails to
operate.
Washing machine cannot be
filled with water.
Machine is draining while
being filled.
Drainage failure.
Strong vibration while
spinning.
Operation stops before
completing wash cycle.
Operation stops for a period
of time.
Excessive foam in the
drum, which is spilled to the
dispenser drawer.
Automatic adjustment of the
washing time.
Spinning fails
MAINTENANCE
CAUSES
¬ Poor connection to the power supply.
¬ Power failure.
¬ The washer door is not properly closed.
¬ Machine has not been switched on.
¬ The "Start/Pause" button is not pressed.
¬ Water tap is not turned on.
¬ Water pressure is less than 0,03 Mpa.
¬ The inlet hose is kinked.
¬ Water supply failure.
¬ The program knob is not properly set.
¬ The washer door is not properly closed.
¬ The inlet hose filter is blocked.
¬ The height of the drain hose is below 80 cm.
¬ The drain hose is in water.
¬ Drain hose is blocked.
¬ Drain hose end is higher than 100 cm above
the floor level.
¬ The filter is blocked.
¬ Not all transportation bolts have been removed.
¬ Washing machine is located on an uneven
surface or is not level.
¬ Water or electricity failure.
¬ Washing machine gives an error message.
¬ The detergent is not a low-foaming type.
¬ Excessive use of detergent.
¬ The washing program duration will be adjusted
according to the initial water temperature.
¬ Unbalance of the laundry
SOLUTIONS
_ Check connection to the power supply.
_ Check the power supply.
_ Close the washer door properly.
_ Make sure the machine is switched on.
_ press the "Start/Pause" button.
_ Turn on the water tap.
_ Check water pressure.
_ Check the inlet hose.
_ Ensure the water supply.
_ Set the program knob properly.
_ Close the washer door properly.
_ Unblock the inlet hose filter.
_ Install drain hose within 80-100 cm of height.
_ Make sure the drain hose is not in water.
_ Unblock the drain hose.
_ Make sure the drain hose end is lower than
100 cm above floor level.
_ Unblock the filter.
_ Remove all transportation bolts.
_ Make sure the washing machine is on
an even surface and levelled.
_ Reduce amount of laundry in the drum.
_ Check the power supply.
_ Check display codes.
_ Check if your detergent is appropriate.
_ Reduce amount of detergent in the dispenser
drawer.
_ This is normal and doesn't affect the
functionality.
_ Add clothes or run a spinning program again.
19