Whirlpool Cabrio WTW5600XW3 Інструкція з використання та догляду - Сторінка 15

Переглянути онлайн або завантажити pdf Інструкція з використання та догляду для Пральна машина Whirlpool Cabrio WTW5600XW3. Whirlpool Cabrio WTW5600XW3 36 сторінок. Top-loading high efficiency low-water washer

TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.whirlpool.com/product_help
-
In Canada www.whirlpool.ca
for assistance and to possibly avoid a service call.
Incorrect dispenser
operation
Clogged dispensers or laundry
products dispensing too soon.
Residual powder in dispenser.
Solution
Do not overfill dispenser, which causes immediate dispensing.
Always select Fabric Softener option to assure proper dispensing.
Load dispensers before starting a cycle.
Homes with low water pressure may result in residual powder in the
dispenser. To avoid, select a warmer wash temperature if possible,
depending on your load, or use liquid HE detergent.
Use only liquid chlorine bleach in the bleach dispenser.
In wash water temperatures colder than 60 ° F (15.6° C), some
detergents do not dissolve well. Soils may be difficult to remove.
To avoid, select a warmer wash temperature if possible, depending
on your load, or use liquid HE detergent.
Fabric damage
Sharp items were in pockets during
Empty pockets, zip zippers, and snap or hook fasteners before
wash cycle,
washing to avoid snags and tears.
Strings and straps could have tangled.
Tie all strings and straps before starting wash load.
Mend rips and broken threads in seams before washing.
Items may have been damaged before
washing.
Fabric damage can occur if washer
is tightly packed.
Liquid chlorine bleach may have been
added incorrectly.
Button sounds are turned off.
Cycle signal is turned off.
Monthly maintenance not done as
recommended.
Garment care instructions may not
have been followed.
No sounds when
buttons are pressed
No end of cycle signal
Odors
Using wrong or too much detergent.
Lid Locked light
The lid is not closed.
is flashing.
A cycle was stopped or paused using
the START/Pause/Unlock
button.
Single-dose laundry
Adding laundry packet incorrectly.
packet not dissolving
Load garments in loose heaps evenly around the washplate. Do
not load garments directly over the center of the washplate.
Use cycle designed for the fabrics being washed.
Add only 1 or 2 additional garments after washer has started.
Do not pour liquid chlorine bleach directly onto load. Wipe up
bleach spills.
Undiluted bleach will damage fabrics. Do not use more than
recommended
by manufacturer.
Do not place load items on top of bleach dispenser when
loading and unloading washer.
Always read and follow garment manufacturer's
care label
instructions.
See "Cycle Guide" to match your load with
the best cycle.
Button sounds can be turned on or off by pressing and holding
EXTRA RINSE for 6 seconds.
Cycle signal can be turned on or off by pressing and holding
FABRIC SOFTENER for 6 seconds.
Run the Clean Washer with affresh ® cycle after every 30 washes.
See "Washer Care" in Washer Maintenance.
Unload washer as soon as cycle is complete.
Use only HE detergent. Be sure to measure correctly.
Always follow the manufacturer's
directions.
See "Washer Care" section.
Close the lid. The washer will not start or fill with the lid open.
The washer may still be spinning. The lid will not unlock until the
basket has stopped spinning. This may take several minutes if
washing large loads or heavy fabrics.
Be sure laundry packet is added to washer basket before adding
clothes. Do not add packet to dispenser. Follow the manufacturer's
instructions to avoid damage to your garments,
j
15