Acom 1500 Посібник із заміни - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник із заміни для Підсилювач Acom 1500. Acom 1500 9 сторінок. Tube replacement

Orient the silicon rubber chimney (together with the anode clip inside) so that:

- the temperature sensor could be threaded through the small hole later;

- the anode clip stripe could be screwed to its original place.

Now thread, by small steps in parallel, the chimney over the tube plate heat sink.

Keep track not to bend the temperature sensor during this operation! Thread the

temperature sensor into its hole into the rubber chimney.

Clip the spring contact

to the tube plate and precisely orient the nut holes to the UHF-suppressor stripe

holes. Align carefully the rubber chimney, so that its bottom edge firmly touches

the tube deck at the base - otherwise a part of airflow would be exhausted

uselessly and the tube might over-heat!

At last, install the UHF suppressor stripe using two original screws and lock

washers (should have been preserved at previous steps). Tighten the screws

properly.

e) Ensure that after the tube replacement all the amplifier wiring is restored to

its original condition.