Acom 1500 Посібник із заміни - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник із заміни для Підсилювач Acom 1500. Acom 1500 9 сторінок. Tube replacement

remove them earlier since the residual voltages will be still too high! You can

expect a small electric sparkle when the HV crowbar is closing which is normal.

Do not touch any part inside when reassembling the amplifier since

residual

voltages may exist and the tube could be still hot!

At last, install the top cover again as described below. Be careful to align

screws thread to the nuts and do not force them since any captive nut on the

chassis might be damaged.

a) Put the cover above the chassis, while holding its rear edge slightly lifted

(to 2-3cm or 1"). Align its horizontal and the two vertical front edges to the

respective front-panel chutes. Then push gently the cover forwards so that its

front edges enter the panel chutes. Take care especially to the bottom corners.

b) Screw in loosely all 9 pcs of "eco-fix" flange-button head screws. Use a

Philips-2 screwdriver.

c) Tighten all 9 screws properly while pressing continuously the cover forwards

and to the bottom.

- E N D -