Ariston PHN 961 TS/IX/A Інструкція з експлуатації Посібник з експлуатації - Сторінка 11

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Варильна поверхня Ariston PHN 961 TS/IX/A. Ariston PHN 961 TS/IX/A 48 сторінок.

Друкувати сторінку

• Setting the burners to minimum

1. Turn the tap to the low flame position;

2. Remove the knob and adjust the adjustment

screw, which is positioned in or next to the tap

pin, until the flame is small but steady.

3. Having adjusted the flame to the required low setting, while the burner is

alight, quickly change the position of the knob from minimum to maximum

and vice versa several times, checking that the flame does not go out.

4. Some appliances have a safety device )thermocouple( fitted. If the device

fails to work when the burners are set to the low flame setting, increase

this low flame setting using the adjusting screw.

5. Once the adjustment has been made, replace the seals on the by-passes

using sealing wax or a similar substance.

! If the appliance is connected to liquid gas, the regulation screw must be

fastened as tightly as possible.

! Once this procedure is finished, replace the old rating sticker with one

indicating the new type of gas used. Stickers are available from any of our

Service Centres.

! Should the gas pressure used be different (or vary slightly) from the

recommended pressure, a suitable pressure regulator must be fitted to the

inlet pipe (in order to comply with current national regulations).

DATA PLATE

Electrical

see data plate

connections

This appliance conforms to the following

European Economic Community directives:

- 2006/95/EC dated 12/12/06 (Low Voltage)

and subsequent amendments

- 2004/108/EC dated 15/12/04

(Electromagnetic Compatibility) and

subsequent amendments

- 93/68/EEC dated 22/07/93 and subsequent

amendments.

- 2009/142/EC dated 30/11/06 (Gas) and

subsequent amendments

- 2012/19/EU and subsequent amendments.

EU Regulation no. 66/2014 implementing

ECODESIGN

Directive 2009/125/EC.

standard EN 30-2-1