3Com 3C433279A Примітка до випуску - Сторінка 11
Переглянути онлайн або завантажити pdf Примітка до випуску для Мережеве обладнання 3Com 3C433279A. 3Com 3C433279A 12 сторінок. Superstack ii remote access system 1500
Frame Relay Local
Management
Interface
RAS1500>DISABLE DATALINK PPP INTERFACE rm0/wan:1
RAS1500>DELETE USER <USERNAME>
RAS1500>DELETE DATALINK PPP INTERFACE rm0/wan:1
b) You may add a new entry in the LAN-to-LAN or the Shared ISP, through
the Web Configurator, based on your needs.
The Local Management Interface (LMI) is a set of enhancements to the
basic Frame Relay specification. It is supported by the RAS 1500 and set
ON to ANSI T1.617 Annex –D by default.
However, make sure that your Frame-Relay service provider supports this
feature.
Some Frame-Relay providers require you to turn this feature OFF.
To disable LMI on your WAN port, use the following command at the CLI
prompt
: SET FRAME_RELAY ON INTERFACE RM0/WAN:1 MANAGEMENT_TYPE
NO_LMI
About LMI: LMI virtual circuit status messages provide communication
and synchronization between Frame Relay DTE and DCE devices. These
messages are used to periodically report on the status of PVCs,
preventing data from being sent into black holes (that is, over PVCs that
no longer exist).
The LMI global addressing extension gives Frame Relay DLCI values global
rather than local significance. DLCI values become DTE addresses that are
unique in the Frame Relay WAN.
Operational Information
11