Whirlpool 4322658A Посібник - Сторінка 21

Переглянути онлайн або завантажити pdf Посібник для Холодильник Whirlpool 4322658A. Whirlpool 4322658A 48 сторінок. In-door ice system

Друкувати сторінку

To reinstall the motor:

a) Remove the two screws from the hex

drive shaft coupling holder and remove

the coupling assembly.

Hex Drive Shaft Coupling

Screw

b) Install the hex drive shaft in the motor

as far as it will go.

c) Slide the new motor assembly back into

place in the freezer door and mount it

with the four screws you removed ear-

lier. Make sure that the top of the hex

drive shaft, spring, and pin are through

the hole in the ice container plate.

NOTE: On 2002, and later models, the

pin is not used.

Spring

Hex

Drive

Shaft

Screw

Coupling

Holder

d) Plug the harness connector into the mo-

tor. NOTE: The connector is designed

to fit only one way on the motor termi-

nals.

e) Position the motor housing cover so that

the raised center faces the motor, and

mount it in place with the two screws

you removed earlier.

f) Make sure that the spring and pin are

in the center hole of the hex drive shaft,

and that the bearing and seal are prop-

erly positioned on the coupling, as

shown.

g) Position the coupling assembly over the

spring-loaded pin, then push down on

the coupling and align it with the top of

the hex drive shaft. Secure the coupling

assembly with the two screws you re-

moved earlier.

Continued on the next page.

4-7

Coupling

Seal

Bushing

Hex Drive

Shaft

Push Down

On Coupling