Ariston TVF 75C Інструкція з експлуатації - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Сушарка Ariston TVF 75C. Ariston TVF 75C 18 сторінок. Tumble dryer
Друкувати сторінку
19510317700
English, All Logos to be Ariston
Installation
Where to put your dryer
GB
• Place your dryer at a distance from gas ranges,
stoves, heaters, or cook tops because flames can
damage the appliance.
• If you are going to install the appliance under a work
• Make sure you put your dryer in an environment that is
not damp and has proper air circulation throughout.
The dryer will not operate efficiently in an enclosed
space or cupboard.
!
We do not recommend that the dryer be installed in a
cupboard because dangerous levels of heat can build
! The appliance must not be installed behind a lockable
door, a sliding door or a door with a hinge on the opposite
side to that of the tumble dryer in such a way that a full
opening of the tumble dryer door is
Ventilation
This Dryer dries your laundry by drawing in cool, clean and
relatively dry air, heating it, and then distributing it
through the clothes as they are gently tumbled. For
optimum performance, the moist air is then blown out
through a vent tube behind the dryer. When the dryer is
in use, there has to be adequate ventilation to avoid a
back flow of gases into the room from appliances burning
other fuels, including open fires.
Mobile venting
A vent tube must always be fitted when the dryer is used
in conjunction with Mobile venting. The tube must be
fitted securely into the back of the dryer (see Dryer
Description). If possible, it is always best to connect the
tube to a permanent vent close to the dryer. If permanent
installation is not possible, the dryer will work just as well
with the tube passing through a partly-opened window.
Ensure that the end of the tube is not directed toward
!
the air intake vent at the rear of the dryer.
counter, be sure to
leave a 10 mm space
between the top and
any other objects on
or above the
machine and a 15
mm space between
the sides and lateral
furnishings or walls.
This is to ensure
proper air circulation.
Make sure that the
back vents are not
obstructed
restricted.
3
{PDF Created 18/01/13 22:04:00}
! The vent tube should not exceed 2,4 m in length, and
should be kept free of any possible accumulation of
fluff, lint, and water by shaking it out frequently. Always
ensure that the tube is not squashed.
Permanent venting
In conjunction with the vent tube we recommend
using a Wall/Window Vent Kit, available at a retail
location or the nearest Spare Parts Dealer:
Depending upon how often you use your dryer, it is
essential that areas A and B are checked periodically
to remove lint or debris. The vent tube adaptor must
be fitted securely thus preventing any humid air from
being emitted back into the room.
! The Dryer should not be pushed so far back that the
tube adaptor is pulled out of position or the tube is
squashed or bent.
! The tube should be kept clear of the air intake vent
and kinks or 'U' bends must be avoided as these will
obstruct the tube and trap condensation.
TD4001FAUS Issu e 1
Wall mounting
1. Leave an opening in
the wall to the left of
dryer's intended position.
2. Keep the tube as
short and straight as
possible
to
prevent
condensed
moisture
from backing up into
the dryer.
3. Similarly, the duct in the
wall should slope
downwards towards the
outside.
Window mounting
1. With a stacked dryer
the hole in the
window should ideally
be made below the
vent.
2. The tube should be
kept as short as
possible.