Clairlone CLF45101W SS Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Холодильник Clairlone CLF45101W SS. Clairlone CLF45101W SS 18 сторінок.

Electrical Connection

WARNING

Improper use of the grounded plug can result in the risk of electrical shock. If the power

cord is damaged, have it replaced by an authorized service center.

This appliance should be properly grounded for your safety. The power cord of this appliance is

equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the

possibility of electrical shock.

Do not under any circumstances cut or remove the third ground prong from the power cord supplied.

DO NOT USE AN EXTENSION CORD. Do not connect your refrigerator to an extension cord or

together with any other appliance in the same wall outlet. Do not splice the cord.

This appliance requires a standard 110/120 volt, 60Hz electrical outlet with three-prong ground.

The cord should be secured behind the appliance and not left exposed or dangling to prevent

accidental injury.

Reversing the Door Swing of your Appliance

This appliance has the capability of either opening the door from the left or right side. The unit is

delivered to you with the door opening from the left side. Should you need to reverse the opening

direction, please follow the instructions pertaining to your particular model.

NOTE: All parts removed must be saved to do the reinstallation of the door.

For models CLF18101WD (1.8 cu.ft.) and CLF32101W (3.2 cu.ft.), and BELF3210P(3.2 cu.ft.)

1. Remove door plate screws from the underside of the fridge, on the right side.

2. Unscrew and remove the left foot.

3. Using a sharp object, pry out the 3 plug buttons on the top. Save the plugs for later use.

4. Remove the upper hinge cover.

5. Remove the 2 Phillips screws which connect the upper hinge to the cabinet top.

6. Carefully lift the door, placing it on a padded surface to avoid scratching.

7. Set the refrigerator door in its new position, making sure the hinge pin enters the bushing at the

bottom of the cabinet.

8. While holding the door in the closed position, loosely secure the upper hinge using the parts

removed in Step 5. Before tightening the screws, make sure the top of the door is level with the

cabinet top.

9. Secure bottom plate with the screws

10. Switch left foot to the right side and secure.

11. Replace upper hinge cover.

12. Replace all 3 plugs removed in step 3 to cover the holes at the right.