Firenzo HASTINGS 4.8KW Інструкція з монтажу Посібник з монтажу - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Дров'яна піч Firenzo HASTINGS 4.8KW. Firenzo HASTINGS 4.8KW 19 сторінок. 4.8kw free standing wood burning stove
Друкувати сторінку7. Installing the stove
1.
Remove all outer packaging and carefully dispose.
2.
Remove top casting and carefully set aside.
3.
Carefully lift fire into approximate position on the floor protector.
4.
Carefully fit the three baffle bricks (located in wrapping in the fire box) anchoring each upon the
securing pin located on the rear baffle cradle and resting on the air tube toward the front of the fire box
(diagram 3 below). It is essential these are fitted or the warranty will be deemed null and void. (See
the installation sheet located with the wrapped baffle bricks)
5.
Fit top casting on to fire box ensuring a good seal to the rope bed.
6.
Accurately position the fire ensuring all necessary safety clearances are adhered to along with the
correct alignment of the flue system to the spigot outlet.
7.
Assemble and install flue system accordingly to comply with all national and local regulations.
8.
Fit with the screw provided the air control (damper) knob situated under the door to the right (diagram
1 below). The air control knob is the smaller of the two knobs supplied (located in wrapping in the fire
box).
9.
Fit door knob (diagram 2 below). The door knob is the larger of the two knobs supplied (located in
wrapping in the fire box).
10. Commission stove to ensure correct operation and adequate flue draw.
11. Super clean burn features: The design and construction of the Napier stove means it burns at a very
high and intense heat. The 4 way air system ensures complete combustion of the logs resulting in an
extremely clean burning process leaving very little, but ash, at the end. The stove owner may
experience varying amounts of super fine ash particles that cling to the glass at different cycles of the
burn process leaving what appear to be white marks. This ash is the result of your stove working to
peak performance. These super fine ash particles cling to the glass because of the temperature
difference between the glass surface and the intense heat of the fire. If experienced, it can be
removed by simply dusting off with a soft cloth when the stove is off, or has been allowed to cool
down.
12. On completion of the installation and commissioning ensure that the operating instructions for the stove
are left with the customer. Ensure to advise the customer on the correct use of the appliance and warn
them to use only the recommended fuel for the stove.
HI-2014-06-09
1
2
Baffle rests on air tube
Baffle
8
3
Baffle rests on
baffle cradle