Clam RUNNER KIT Посібник із швидкого старту - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Автомобільні аксесуари Clam RUNNER KIT. Clam RUNNER KIT 2 сторінки. For: x200 / x400
Також для Clam RUNNER KIT: Посібник із швидкого старту (2 сторінок), Посібник із швидкого старту (2 сторінок)
Друкувати сторінку
QTY.
PART NO.
2
103404
1
103423
1
101550
30
102516
30
101548
30
101549
For the Yukon, Yukon TC and Runner Thermal models, CUT THE RUNNERS TO 64" in length.
For Voyager, Voyager TCX, Tundra and Thermal X models, NO CUTTING IS REQUIRED.
1. Position the strips on the base. Using a 3/16" or slightly larger drill bit, drill a hole through runner strip
and base starting at the curved end of the base.
2. Slightly tighten fasteners to hold the strip in place so that you may then bend the runner around the
curved area before drilling the next hole
(If you have trouble bending the Wear Strip to the contour of the base, use a heat gun or hair dryer to
make the Strips more pliable before drilling.)
( Also, apply a small amount of grease to threads of screw to prevent seizing of threads.)
3.
Drill next hole through the runner strip and base and slightly tighten fastener to hold the runner in
place.
4. Keep repeating this procedure EVENLY SPACING for remaining holes and securely tighten all
fasteners when they are all installed.
5 . Repeat same process for remaining runners.
START HERE
PARTS LIST
DESCRIPTION
RUNNER, .3/8 X 2-1/2 X 74 LG
INSTRUCTION, RUNNER KIT
KIT, HARDWARE RUNNER
SCREW,10-24 X 1" PTHMSSS
NUT, 10-24 NYLOCK SS
WASHER, #10 FENDER SS
Runner Kit Installation
64"
74"
(includes the following)
YUKON / YUKON TC- / RUNNER THERMAL
VOYAGER / VOYAGER TCX / ADVENTURE
TUNDRA / THERMAL X / PORTAGE
START HERE