Whirlpool 27' Інструкція з монтажу Посібник з монтажу - Сторінка 4

Друкувати сторінку

Whirlpool 27' Інструкція з монтажу Посібник з монтажу

INSTALLATION REQUIREMENTS

TOOLS AND PARTS

Parts needed:

(Not supplied with washer/dryer)

Inlet hoses with

flat washers

Check local codes, electrical supply and venting, and read

"Electrical Requirements" and "Venting Requirements" before

purchasing parts. Mobile home installations require metal

exhaust system hardware available for purchase from the

dealer from whom you purchased your washer/dryer. For

further information, please reference the "Assistance or

Service" section of the Washer/Dryer Use and Care Guide.

Optional equipment:

(Not supplied with washer/dryer)

Refer to your Use and Care Guide for information about

accessories available for your washer/dryer.

Vent clamps

Vent elbows and ductwork

Alternate parts:

(Not supplied with washer/dryer)

Your installation may require additional parts. To order, please

refer to toll-free numbers on back page of your Use and Care

Guide.

If you have:

Overhead sewer

Floor drain

1" (25 mm) standpipe

Laundry tub or

standpipe taller than

96" (2.4 m)

Drain hose too short

Lint clogged drain

Water faucets

beyond reach

of fill hoses

You will need:

Standard 20 gal. (76 L) 39" (990 mm)

tall Drain Tub or Utility Sink, Sump

Pump and Connectors (available from

local plumbing suppliers)

Siphon Break Part Number 285320,

Additional Drain Hose Part Number

285702, and Connector Kit Part

Number 285442

2" (51 mm) diameter to 1" (25 mm)

diameter Standpipe Adapter

Part Number 3363920,

Connector Kit Part Number 285835

Sump pump system (if not already

available)

Extension Drain Hose

Part Number 285863,

Connector Kit Part Number 285835

Drain Protector Part Number 367031,

Connector Kit Part Number 285835

2 longer water fill hoses:

6 ft (1.8 m) Part Number 76314,

10 ft (3.0 m) Part Number 350008