Whirlpool 29" Wide Models Інструкція з монтажу Посібник з монтажу - Сторінка 18

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Сушарка Whirlpool 29" Wide Models. Whirlpool 29" Wide Models 20 сторінок. Dryer
Також для Whirlpool 29" Wide Models: Інструкція з монтажу Посібник з монтажу (48 сторінок), Інструкція з монтажу Посібник з монтажу (22 сторінок)

Друкувати сторінку

Level Dryer

Check levelness of dryer from side to side. Repeat from

front to back.

NOTE: The dryer must be level for the moisture sensing system

to operate correctly.

Not Level

LEVEL

Tighten and adjust leveling legs

If dryer is not level or the same height as the washer, prop up

using a wood block. Use wrench to adjust legs up or down,

and check again for levelness. Once legs are level, make sure

all four legs are snug against the floor before tightening them.

Complete Installation Checklist

Check that all parts are now installed. If there is an extra

part, go back through steps to see what was skipped.

Check that you have all of your tools.

Dispose of/recycle all packaging materials.

Check dryer's final location. Be sure vent is not crushed

or kinked.

For power supply cord installation, plug into an outlet.

For direct wire installation, turn on power.

Check that dryer is level. See "Level Dryer".

Remove film on console and any tape remaining on dryer.

Wipe dryer drum interior thoroughly with a damp cloth to

remove any dust.

Read "Dryer Use" in your "Use and Care Guide".

Set the dryer on a full heat cycle (not an air cycle) for

20 minutes and start the dryer.

NOTE: You may notice an odor when the dryer is first heated.

Not Level

This odor is common when the heating element is first used.

The odor will go away.

Reverse Door Swing (Optional)

29" Super Wide Side-Swing Door

Place towel on top of dryer to avoid damaging the surface.

NOTE: Magnetized screw driver is helpful.

Open dryer door. Remove bottom screws from dryer cabinet

side of hinges. Loosen (do not remove) top screws from dryer

cabinet side of hinges.

Be sure the water faucets are on.

Check for leaks around "Y" connector, faucet, and hoses.

If you live in a hard water area, use of a water softener is

recommended to control the buildup of scale through the

water system in the dryer. Over time, the buildup of lime

scale may clog different parts of the water system, which will

reduce product performance. Excessive scale buildup may

lead to the need for certain part replacement or repair.

If the dryer will not start, check the following:

Controls are set in a running or "On" position.

■

Start button has been pushed firmly.

■

Dryer is plugged into an outlet and/or electrical supply

■

is on.

Household fuse is intact and tight, or circuit breaker has

■

not tripped.

Dryer door is closed.

■

When the dryer has been running for 5 minutes, open the

dryer door and feel for heat. If you feel heat, cancel cycle

and close the door.

If you do not feel heat, turn off dryer, and check the

following:

There may be 2 household fuses or circuit breakers for

■

the dryer. Check that both fuses are intact and tight, or

that both circuit breakers have not tripped. If there is still

no heat, contact a qualified technician.

Place towel on dryer

Remove bottom screws