Whirlpool 3RAWZ481G Інструкція з монтажу Посібник з монтажу - Сторінка 11
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Сушарка Whirlpool 3RAWZ481G. Whirlpool 3RAWZ481G 25 сторінок. Electric and gas dryer
Також для Whirlpool 3RAWZ481G: Інструкція з використання та догляду (24 сторінок), Посібник з використання та догляду (28 сторінок)
Друкувати сторінку
Complete installation
1. Check to be sure all parts are now
installed. If there is an extra part, go
back through the steps to see which
step was skipped.
2. Check to be sure you have all of your
tools.
3. Dispose of all packaging materials.
4. Check the dryer's final location. Be sure
the vent is not crushed or kinked.
5. Check to be sure the dryer is level. (See
"Level Dryer.")
6. Plug into an earthed electrical socket-
outlet. Turn power on.
7. Remove the blue protective film on the
console and any tape remaining on the
dryer.
Moving dryer to a new location?
Check with your gas supplier or dealer to confirm that your dryer is equipped with the
correct burner for the particular type of gas in your new location. Burner information is
specified on the model/serial rating plate.
Shut off electrical
supply to dryer.
Unplug power
supply cord and tape it
securely to dryer.
Shut off gas supply
valve in the gas
supply line.
Disconnect gas fittings
from dryer and cap gas
supply line. Tape end of
dryer gas pipe.
Slide dryer onto cardboard or hardboard
before moving it across the floor to prevent
damaging floor covering.
8. Read "Dryer Use."
9. Wipe the dryer drum interior thoroughly
with a damp cloth to remove any dust.
10. Set the dryer on a full heat cycle (not
an air cycle) for 20 minutes and start
the dryer.
If the dryer will not start, check the
following:
• Dryer is plugged into an earthed
electrical socket-outlet.
• Electrical supply is connected.
• House fuse is intact and tight; or circuit
breaker has not tripped.
• Dryer door is closed.
Tape top
to cabinet.
Tape door to
front panel.
Turn leveling
legs all the way
in.
11. When the dryer has been running for 5
minutes, open the dryer door and feel
for heat. If you do not feel heat, turn
the dryer off and check to see if the
gas supply line shutoff valve is open.
• If the gas supply line shutoff valve is
closed, open it, then repeat the 5-minute
test as outlined above.
• If the gas supply line shutoff valve is
open, contact a qualified technician.
11