Whirlpool 3XLER5437 Інструкція з використання та догляду - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з використання та догляду для Сушарка Whirlpool 3XLER5437. Whirlpool 3XLER5437 36 сторінок. Electric and gas dryer
Також для Whirlpool 3XLER5437: Інструкція з використання та догляду (32 сторінок), Посібник з використання та догляду (36 сторінок), Посібник з використання та догляду (40 сторінок)
Друкувати сторінку
3. Turn the Cycle Control knob to the recommended cycle for
the type of load being dried. See "Drying, Cycle and
Temperature Tips."
4. Select a temperature setting on models with a Temperature
selector. The cycle descriptions include temperature setting
suggestions.
NOTE: The temperature selector is part of the Cycle Control
knob on some models.
5. Select the End of Cycle Signal, if available. The signal is
helpful when drying permanent press or synthetics. Promptly
remove these items from the dryer at the end of the cycle to
prevent wrinkles.
6. Press PUSH TO START. Your gas dryer has an electronic
ignition system for the burner which is fully automatic; no
action is needed by the user (there is no pilot light).
NOTE: Your dryer stops automatically when a cycle ends.
Stopping and Restarting
You can stop your dryer anytime during a cycle.
To stop your dryer
Open the dryer door or turn the Cycle Control knob to OFF.
NOTE: The Cycle Control knob should point to an Off area when
the dryer is not in use.
To restart your dryer
1. Close the door.
2. Select a new cycle and temperature (if desired).
3. Press PUSH TO START.
Drying, Cycle and Temperature Tips
Select the correct cycle and temperature for your load.
Cool Down tumbles the load without heat during the last few
minutes of all cycles to make the load easier to handle.
Drying tips
Follow care label directions when they are available.
If desired, add a fabric softener sheet. Follow package
instructions.
Remove the load from the dryer as soon as tumbling stops, to
reduce wrinkling. This is especially important for permanent
press, knits and synthetic fabrics.
Cycle and temperature tips
Use a High heat setting for drying heavyweight items such as
towels, work clothes and sheets.
Use a Low heat setting for drying lightweight items such as
lingerie, underwear, blouses, dresses, permanent press
fabrics and some knits.
Use a no-heat (air) setting for rubber, plastic or heat-sensitive
fabrics.
Line dry bonded or laminated fabrics.
NOTE: If you have questions about drying temperatures for
various loads, refer to the care label directions. If you are unsure
of the temperature to select for a load, select a lower setting
rather than a higher setting.
8
Dryer Symbols
The control panel of your dryer contains symbols. Refer to the
chart below for a definition of those symbols.
Symbols
Cool Down
TUMBLE PRESS
Cycle
Damp Dry
Timed Drying
Delicates
Quick Dry
Synthetics/
Permanent Press
Cotton
Heavy
Symbols
Low/Knits
Medium/
Permanent Press
High/Heavy
Temperature
On
Off
Push to Start
Push to Start
Air Fluff