Whirlpool AWD712S2 Посібник користувача та онлайн-гарантія - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник користувача та онлайн-гарантія для Сушарка Whirlpool AWD712S2. Whirlpool AWD712S2 44 сторінки.

3.4 Select cycle

Select the cycle based on the clothing loaded in the dryer.

Select the desired options.

The Quick option is available only for the Jeans, Towels and Normal cycles.

Quick option and Half Load option cannot be selected at the same time.

Press the

START/PAUSE

If the dryer does not start up, press the button on the back of the dryer to reset the

NOTE:

protection thermostat and press Start/Pause again. If the problem persists, check to see if the

ventilation system is obstructed or contact your service agent or qualified personnel.

Now the drum will begin to spin.

The drum will periodically stop and rotate in the other direction for a short period of time. This

will repeated throughout the entire drying cycle. It is important to take into account that the first

stop period may be longer than following ones.

If the clothing is dried before the cycle ends, or if an excessively long cycle time has been

selected, the built-in thermostat will automatically turn off the heater to prevent the clothing

from being over-drying and save energy, even though the drum will continue to rotate.

Simply open the door in the middle of a cycle to stop the machine; the drum will stop rotating

automatically.

Press the

START/PAUSE

There is an automatic 30-minute period at the end of each cycle which helps to smooth

out wrinkles. During this period, the dryer will make periodic rotations.

3.7

Remove clothing as soon as the cycle has completed in order to reduce wrinkles.

NEVER UNPLUG THE DRYER AND LEAVE A WARM LOAD IN THE DRUM.

If any individual items are still damp after the drying cycle has completed, extend the drying

process by setting to a 30 minutes drying cycle. This will be required especially for

multi layered items such as pockets, collars etc.

button to start the cycle.

button again to restart the cycle.