Whirlpool Cabrio WGD6600WL0 Посібник з використання та догляду - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з використання та догляду для Сушарка Whirlpool Cabrio WGD6600WL0. Whirlpool Cabrio WGD6600WL0 48 сторінок. Steam fabric care system gas dryer

Whirlpool Cabrio WGD6600WL0 Посібник з використання та догляду
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
To reduce the risk of fire, electric shock, or injury to persons when using the dryer, follow basic precautions,
including the following:
[]
Read all instructions
before using the dryer.
[]
Do not place items exposed to cooking
oils in your dryer.
Items contaminated
with cooking
oils may contribute
to
a chemical reaction that could cause a load to catch fire.
[]
Do not dry articles that have been previously cleaned in,
washed in, soaked in, or spotted with gasoline, dry-
cleaning solvents, or other flammable or explosive
substances
as they give off vapors that could ignite or
explode.
[]
Do not allow children to play on or in the dryer. Close
supervision
of children is necessary when the dryer is
used near children.
[]
Before the dryer is removed from service or discarded,
remove the door to the drying compartment.
[]
Do not reach into the dryer if the drum is moving.
[]
Do not install or store the dryer where it will be exposed
to the weather.
[]
Do not tamper with controls.
[]
Do not repair or replace any part of the dryer or attempt
any servicing unless specifically recommended
in this
Use and Care Guide or in published user-repair
instructions that you understand and have the skills to
carry out.
[]
Do not use fabric softeners or products to eliminate static
unless recommended
by the manufacturer
of the fabric
softener or product.
[]
Do not use heat to dry articles containing
foam rubber or
similarly textured rubber-like materials.
[]
Clean lint screen before or after each load.
[]
Keep area around the exhaust opening and adjacent
surrounding
areas free from the accumulation
of lint, dust,
and dirt.
[] The interior of the dryer and exhaust vent should be
cleaned periodically
by qualified service personnel.
[]
See installation instructions
for grounding
requirements.
SAVE THESE INSTRUCTIONS
IMPORTANT: The gas installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas
I
Code, ANSI Z223.1/NFPA 54 orthe Canadian Natural Gas and Propane Installation Code CSA B149.1.
I
The dryer must be electrically grounded in accordance with local codes or in the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22.1.
INSTALLATION INSTRUCTIONS
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
8" or 10" pipe wrench
8" or 10" adjustable
wrench (for gas
connections)
Flat-blade screwdriver
1/4" nut driver or socket
wrench
Knife
Vent clamps
Pipe-joint compound
resistant to LP gas
Parts supplied:
Remove parts package from dryer drum. Check that all parts
were included.
Adjustable wrench that
opens to 1" (2.5 cm) or
_
_
hex-head socket wrench
Caulking gun and
(for adjusting dryer feet)
compound
(for installing
new exhaust vent)
Level
A
B
C
D
E
Pliers
A. Leveling legs (4)
B. "Y" connector
C. Short inlet hose
D. Inlet hose with right-angle
connecter
E. Rubber washer
4