Whirlpool CABRIO WGD8800YW0 Інструкція з монтажу Посібник з монтажу - Сторінка 15
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Сушарка Whirlpool CABRIO WGD8800YW0. Whirlpool CABRIO WGD8800YW0 36 сторінок. Gas dryer
Також для Whirlpool CABRIO WGD8800YW0: Інструкція з використання та догляду (36 сторінок)
Друкувати сторінку
REVERSE DOOR SWING
You can change your door swing from a right-side opening
to a left-side opening, if desired.
1. Place a towel or soft cloth on top of dryer or work space
to avoid damaging the surface.
Remove the door assembly
1. Open the dryer door.
2. Remove the bottom screw (B) from each of the two hinges
that attach dryer door to front panel of dryer.
3. Loosen the top screw (A) from each of the two hinges
in Step 2.
4. Remove the dryer door and the hinges by lifting upward
on the door. Lay the door on a flat, covered surface, with
the inside of the door facing up. Remove remaining two
loose screws from dryer front panel.
5. Remove the 4 plastic plugs (A) located outside the dryer
door opening.
A
A
A
A
6. Install 4 plastic plugs (A) into screw holes in the dryer left
where the hinges were removed in Step 4.
Reverse the strike
1. Remove the door strike (A) from the dryer door opening.
2. Remove the cosmetic screw (B) opposite the door strike (A).
A
A
B
3. Reinstall the door strike and cosmetic screw on the opposite
side of dryer door opening from where they were removed.
A
NOTE: Door strike and plugs must be on the same side
of the dryer door opening.
B
Reinstall the door
1. Remove the 4 screws and two hinges from the dryer door.
2. Replace the 4 screws in the same holes
3. Remove the 4 screws from the opposite side of the door.
A. Door strike
B. Cosmetic screw
B
15