Clam Corp 8202 Інструкція з експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Спорядження для кемпінгу Clam Corp 8202. Clam Corp 8202 12 сторінок. Clam corporation inc. clam 6800 instruction manual
Друкувати сторінку
BEFORE ATTEMPTING TO USE THIS PRODUCT ON THE ICE practice setting up and taking
down at home in the comfort of a heated area. Repeat several times until comfortable. This will make
your on-ice set-up much easier.
NO TOOLS ARE NEEDED FOR ASSEMBLY OF YOUR CLAM 6800.
1.
INITIAL SET-UP
a. Open the Clam 6800 and lay on a flat level surface.
b. Lift up the two hoop pole sections until the snap button locks into place. Lock the braces.
See Diagram A. (Both ends.)
c. Unfold the tent and unzip both doors. Pull the tent over the two hoop poles.
d. Above each tent door, on the top of the seam, you will see three velcro strips. Attach the three
velcro strips to the hoop poles. See Diagram B.
2. INSERT POLES
a. Insert the four spreader tubes (#7) on each end of the hoop pole. See Diagram C.
b. Adjust the spreader tubes until the hoop poles are at a 90 degree angle and tent is snug,
then tighten the adjustment knob.
c. Install the two dome poles (#8) in the center of the 6800. Install each dome pole in line with
the velcro on the roof. Attach the velcro to the dome poles. See Diagram D.
poles are the non-adjustable poles.)
3. FASTEN THE TENT
a. Fasten the tent to the base by inserting the strap from the tent through the back of the buckle.
See Diagram E. Pull the strap until the elastic on the buckle starts to stretch. Do not over
stretch the elastic straps.
b. Fold the tab on the buckle over and all the way down to fasten. See Diagram F.
only needs to be done the first time you set up your 6800.)
4.
INSTALL LICENSE
a. Locate the clear sleeve sewn to the outside of the tent. Slide the required documention of
you area into the sleeve for display.
Page 6
ASSEMBLY INSTRUCTIONS
(Check with local authorities for the requirements of your area.).
(Note: The dome
(Note: This