Whirlpool GEQ8811PL0 Інструкція з монтажу Посібник з монтажу - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Сушарка Whirlpool GEQ8811PL0. Whirlpool GEQ8811PL0 24 сторінки. 27 in. (69cm) electric dryer
Друкувати сторінку
6. Connect a separate copper ground w ire from theexternal
ground c onnector screw toanadequate ground.
1. External ground connector
2. Neutral grounding
wire (green/yellow)
3. Neutral wire (white or center wire)
4. Grounding path determined
by a qualified electrician
Fire Hazard
Use a heavy metaB vent,
Do not use a pmaetic vent,
Do not use a metam foil vent.
Failure to follow
these instructions
can result in death
or fire.
WARNING;
To reduce the risk of fire, this dryer MUST BE
EXHAUSTED OUTDOORS.
4 in. (10.2 cm) heavy metal exhaust vent and clamps must be
used. DURASAFE
TM
venting products are recommended.
DURASAFE
TM
vent products can be purchased from your dealer
or by calling Whirlpool Parts and Accessories.
For more
information, see the "Assistance
or Service" section of your
"Dryer User Instructions."
•
Do not exhaust the dryer into any gas vent, chimney, wall,
ceiling, or a concealed space of a building.
•
Do not use an exhaust hood with a magnetic latch.
•
Do not install flexible metal vent in enclosed walls, ceilings or
floors.
•
Do not use screws or other fastening devices that extend into
the interior of the vent to secure vent.
IMPORTANT: Observe all governing codes and ordinances.
_mproper venting
can cause moisture
and mintto collect
indoors,
which
may resumt in:
[]
Moisture damage to woodwork,
furniture, paint, waif
paper, carpets, etc.
[]
Housecleaning
problems and health problems.
Use a heavy metal vent. Do not use plastic or metal foil vent.
Rigid metal vent is recommended to prevent crushing and kinking.
Flexible metal vent must be fully extended and supported when
the dryer is in its final position. Remove excess flexible metal vent
to avoid sagging and kinking that may result in reduced airflow
and poor performance.
An exhaust hood should cap the vent to prevent rodents and
insects from entering the home.
Exhaust hood must be at least 12 in. (30.5 cm) from the ground or
any object that may be in the path of the exhaust (such as flowers,
rocks or bushes, etc.).
If using an existing vent system, clean lint from the entire length of
the system and make sure exhaust hood is not plugged with lint.
Replace any plastic or metal foil vent with rigid metal or flexible
metal vent.
Use clamps to seal all joints. Do not use duct tape, screws or
other fastening devices that extend into the interior of the vent to
secure vent.
Typical exhaust
installations
Typical installations vent the dryer from the rear of the dryer. Other
installations are possible.
1
•
2
4
............
8
1. Dryer
2. Elbow
3. Wall
4. Exhaust hood
5. Clamps
6. Rigid metal or flexible metal vent
7. Vent length necessary to connect elbows
8. Exhaust outlet