Whirlpool WGD95HEXL1 Посібник з використання та догляду - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник з використання та догляду для Сушарка Whirlpool WGD95HEXL1. Whirlpool WGD95HEXL1 40 сторінок. Electronic dryer
Друкувати сторінку
State of California Proposition 65 Warnings:
WARNING: This product contains a chemical known to the State of California to cause cancer.
WARNING: This product contains a chemical known to the State of California to cause birth defects or other reproductive
harm.
In the State of Massachusetts,
the following installation instructions apply:
[] Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by
the State of Massachusetts.
[] If using a ball valve, it shall be a T-handle type.
[] A flexible gas connector, when used, must not exceed 3 feet.
WARNING:
For your
safety, the information
in this manual
must be followed
to minimize
the risk of fire or explosion,
or to prevent
property
damage,
personal
injury, or death.
- Do not store or use gasoline
or other flammable
vapors and liquids
in the vicinity
of this
or any other
appliance.
- WHAT TO DO IF YOU SMELL GAS:
o Do not try to light any appliance.
• Do not touch
any electrical
switch; do not use any phone in your building.
o Clear the room,
building,
or area of all occupants.
• Immediately
call your gas supplier
from a neighbor's
phone. Follow the gas supplier's
instructions.
o If you cannot reach your gas supplier,
call the fire department.
- installation
and service
must be performed
by a qualified
installer,
service
agency,
or
the gas supplier.
WARNING: Gas leaks cannot always be detected by smell.
Gas suppliers recommend
that you use a gas detector approved
by UL or CSA.
For more information,
contact your gas supplier.
If a gas leak is detected, follow the "What to do if you smell gas" instructions.
iMPORTANT: The gas installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1/NFPA 54.
The dryer must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National
Electrical Code, ANSl/NFPA 70.