Whirlpool WLG7761XW Інструкція з використання та догляду - Сторінка 13
Переглянути онлайн або завантажити pdf Інструкція з використання та догляду для Сушарка Whirlpool WLG7761XW. Whirlpool WLG7761XW 16 сторінок. Extra large capacity automatic dryers
Rsmovescrws
bsfors O~lng
top
Wyourcbyerb~andhaaafullfront
pand,mrnovefrontpanelarfolbwe:
Drum seal
6ids panel
wire
clip-
holds door
1.
2
3.
4.
5.
6.
7.
Unplug the power supply cord or turn
off the electrical power.
Remove lint screen. Remove two
screws in lint screen area.
Open top by pulling forward and up
at each front corner (see view A).
Rest raised top against wall behind
dryer (top is hinged at rear).
Remove two internal screws from
front panel flanges (near top front
comers). Lift front panel slightly,
lifting off lower clips (see view B).
Slowly pull front panel forward,
disengaging
panel from drum. (Drum
will drop slightly.)
Move front panel aside and rest edge
against side of dryer. Avoid discon-
necting wire clips (see view C) or
damaging wires.
Remove lint from area shown in 'gas
dryer' illustration on page 12 with soft
brush or vacuum cleaner. Avoid
damaging wires, funnel or igniter.
Reassemble
in reverse order. Before
.
.
closing the top, check the following:
- Drum seal must be flared out (see
view D) and properly positioned
against panel at back of drum
Rotate drum counterclockwise
one
full turn to check drum seal.
- Belt should be centered and tight
on dryer drum.
- Wire clips which hold the door
switch wires must be anchored in
slot in top of front panel (see
view C) and along top edge of side
panel. Door wires must not touch
drum when dryer is operating.
,
Sea Warning, page 12.
6. Replace top panel and lint screen
screws. Top and front panels must
be securely in place before operating
dryer.
9. Reconnect power and level dryer
again (if necessary).
NOTE:
Call Consumer Assistance
at
1-600-253-l 301 for assistance
or
more information.
13