ABB CoriolisMaster FCH400 Series Посібник з конфігурації - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник з конфігурації для Блок управління ABB CoriolisMaster FCH400 Series. ABB CoriolisMaster FCH400 Series 11 сторінок. Hspc module

Друкувати сторінку

Overview

This guide provides instructions to configure the ABB High Speed Pulse Counter (HSPC) TFIO module

for connection with the ABB CoriolisMaster FCB400 or FCH400 series of Coriolis mass flowmeters.

An HSPC module I/O point is configured as a Pulse Input (PI). This Input connects to one of the

CoriolisMaster's Digital Outputs (Digital Output 41/42).

point schematic for the Pulse Input. Please note that to illustrate the acceptable signal range to the

HSPC input, a graphical representation of this range is shown.

The CoriolisMaster Digital Output 41/42 supports many configuration options. For this guide, it is

assumed that this output is configured as a passive frequency output.

IMPORTANT NOTE: Passive outputs (mentioned in the CoriolisMaster documentation)

the same as Open-Collector outputs (mentioned in HSPC documentation).

Figure 1-1: ABB CoriolisMaster FCB/FCH digital output connected to HSPC digital input

ID Description

CoriolisMaster FCB400/FCH400 series (DO 41/42)

HSPC point schematic (when configured as PI/DI)

Wire the HSPC module input

This procedure describes how to wire an HSPC module point to receive inputs from the CoriolisMaster.

Terminal connector J1 is used to illustrate the connection.

Prerequisites:

–

Tools: Small flathead screwdriver, fine tip marker

–

The HSPC module is not powered.

–

Review and meet wiring requirements (wire gauge, length, use wire-end ferrules, etc.) See the

TFIO Module User Manual (See

–

Determine if the module requires a non-default address. If there are other HSPC modules already

installed, the new module address must be different from the addresses already assigned to the

existing HSPC modules. If there are no other HSPC modules installed, then the new module can

keep the default address (00). For address guidelines, refer to the TFIO Module User Manual.

To wire the HSPC (refer to

Remove the terminal connector from the HSPC module (For this example, J1). With the marker,

make sure you mark pin 1 on the connector as a reference for wiring.

Losen connector screws to prepare wire insertion.

Insert the Signal wire in the Signal point (in this example, J1-1).

Insert Ground wire in the GND point (in this example, J1-2).

Additional

information).

Figure

2-1):

Figure 1-1

shows the HSPC module detailed

ID Description

HSPC PI/DI signal range specifications

HSPC field voltage operation range

21 08 74 4MN A A | HS P C C ON FIG UR AT IO N G UI DE | 3

are