Calandra Racing Concepts Carpet Knife Generation X Series Посібник з монтажу - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник з монтажу для Іграшкова машинка на колесах Calandra Racing Concepts Carpet Knife Generation X Series. Calandra Racing Concepts Carpet Knife Generation X Series 18 сторінок.

Друкувати сторінку

CRC Pro-Strut

Front End - cont.

8-32 x 5/8"

4-40 x 3/8"

Low Head

Flat Head

F.E. Screw

Gray #4 Washer

Red Locknut

Installing the Lower arm to the Chassis

1 - Insert four 4-40 x 3/8" FH screws [41] through the chassis, and

then place two #4 washers [81] over each of the screws before

sliding them through the Front End Plate [79]. Secure these parts

with red locknuts [9].

2 - Now, secure the front end assembly to the plate using the 8-32 x

5/8" low head front end screws [80]. We recommend starting in the

rear hole, as this is the smoother setting. Going longer in the front

end will make the car steer more. Make sure you are using the same

set of holes for both sides!

Installing the Bumper to the Chassis

1 - Insert three 4-40 x 5/16" red FH screws [82] through the

chassis, then through the Bumper [83] Secure these parts

with three red locknuts [9].

4-40 x 5/16"

Red FH