Calandra Racing Concepts Carpet Knife Generation X Series Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з монтажу для Іграшкова машинка на колесах Calandra Racing Concepts Carpet Knife Generation X Series. Calandra Racing Concepts Carpet Knife Generation X Series 18 сторінок.

Друкувати сторінку

Rear X-Pod

Bag 3

2-56 Steel

Red Locknut

Ballstud - Black

Graphite

Top Plate

1 - Install the black 2-56 ballstuds [15] into the graphite top plate [16]. These steel balls thread into the

graphite, no nut is needed. Be sure to start them straight and turn them in slowly so they do not strip or break.

A drop of oil is helpful to avoid breaking the steel ball in the graphite. Also, to avoid breakage, tighten the

ballstud a little and then loosen, then a little tighter, then loosen, working the ballstud into the carbon slowly.

Stop tightening the moment the flat of the steel ballstud contacts the carbon.

2 - Insert a red aluminum 4-40 ballstud [17] through the graphite top plate [16] and tighten it in place with a red

locknut [9].

Red Alum

4-40 Ballstud

Motor Plate

4 - Install the rear pod-brace [19] to the back of the motor

plate [20] and left side pod plate [21]. Use 4 1/4" button head

screws [18] to attach the graphite piece to the pod plates.

5 - Install the completed rear pod assembly to the rear bottom

plate using 4 1/4" flat head screws [22]. Keep an eye on these

screws during the first few runs of your car. They tend to

loosen until they take a "set" and then they WILL stay tight.

Also install

the standoff.

*Note - We do NOT recommend using thread lock in any

application with very small hardware like this. The pieces can

become so locked together that such a small hex wrench will

break and not get the screw out if you ever need to

disassemble it.

In time, the screw will naturally "seat" and stay tight. Just

check on them once in awhile.

Also, keep an eye on the plastic left bulkhead screw holes, if

plastic burrs and flashing forms after repeated use, trim the

burrs with a hobby knife to ensure the part mounts flat.

4-40 x 1/4"

Button Head

Flat Head

Left Side Plate

1 button head screw [18] through the top plate into