Calandra Racing Concepts Gen-X 10 Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з монтажу для Іграшкова машинка на колесах Calandra Racing Concepts Gen-X 10. Calandra Racing Concepts Gen-X 10 19 сторінок.

Друкувати сторінку

Rear X-Pod

Bag 3

Tweak Plates

Bag 4

4-40 x 5/16"

set screw

1 - Install the completed rear pod to the chassis sub-assembly

using 4 red alum flat head screws [23]. Keep an eye on these

screws during the first few runs of your car. They tend to

loosen until they take a "set" and then they'll stay tight.

We do NOT recommend using thread lock in aluminum to

aluminum applications. They will stay tight after being re-

tightened once or twice.

2 - Tighten the top plate to the hex standoff [15] using a red

button head screw [22].

Metal Spring Holder

NSERT

WEAK

CREWS IN

RACE

1 - Place the Tweak Brace [24] on a smooth, flat table and thread the

Tweak set screws [25] into the brace per the illustration. Try to be careful

to thread it in straight and perpendicular.

2 - With the tweak screw threaded through the brace, super glue or thread

lock the tweak screw to the metal spring holder [26] as shown in the

illustration. The tweak screw should thread in until flush with the bottom of

the spring holder.

3 - Repeat the above steps for the second Tweak Plate, but flip the plate

first as this is for the opposite side of the car.

Thread the set screw in until flush

with the bottom of the holder. Add a

dab of super glue to keep these 2

parts secure to each other.

Graphite Tweak

Plate (x2)

SSEMBLY