FirePro FPC-2 Посібник з експлуатації та встановлення - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник з експлуатації та встановлення для Панель керування FirePro FPC-2. FirePro FPC-2 14 сторінок. Fire control panel system isolation
Також для FirePro FPC-2: Посібник з експлуатації та технічного обслуговування (7 сторінок), Посібник з експлуатації та технічного обслуговування (8 сторінок), Посібник із швидкого старту (2 сторінок)

5. Testing and commissioning

IMPORTANT – DISCONNECT ALL FIREPRO AEROSOL GAS GENERATORS

BEFORE TESTING.

With all

Aerosol Gas generators disconnected from the panel, ensure

FirePro

that the test lamps that are supplied with the unit are fitted to terminals

FireproGEN1, FireproGEN2, FireproGEN3 and FireproGEN4.

Do not leave any

gas generators connected to the unit when

FirePro

testing or these units will activate.

Figure 9 - Connections to Firepro

Gen outputs to test system.

Firepro

24V in 24V out Detection

Gen1

Gen2

Gen3

Gen4

+ - + -

+ -

Ensure that both jumper links are fitted in position "A" and trigger the detection

input by operating a smoke detector or linear heat detector. Ensure that the test

lamps connected to the FireproGEN terminals light immediately, the red fire

indicator on the front panel lights, the yellow fault indicator lights and the buzzer

sounds. Press the Buzzer Silence button to silence the buzzer and then the Reset

button to rest the system.

Disconnect the wiring to the detector and ensure that the yellow Fault LED on the

front panel and the internal yellow LED marked LED4 are lit and the buzzer

sounds. Press the buzzer silence button and ensure the buzzer silences. Re-

connect the detector wiring and ensure that the fault indication clears.

Disconnect one of the test lamps and ensure that the yellow Fault LED on the

front panel and the internal yellow LED marked LED5 are lit and the buzzer

sounds. Press the buzzer silence button and ensure the buzzer silences. Re-

connect the test lamp and ensure that the fault indication clears.

Man-1144 Protection controller Operation manual issue 04

Page 10 of 11