Whirlpool 30" AND 36" (76.2 AND 91.4 CM) WALL-MOUNTCANOPY RANGE HOOD Інструкція з монтажу та інструкція з експлуатації та догляду - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з монтажу та інструкція з експлуатації та догляду для Вентиляційна витяжка Whirlpool 30" AND 36" (76.2 AND 91.4 CM) WALL-MOUNTCANOPY RANGE HOOD. Whirlpool 30" AND 36" (76.2 AND 91.4 CM) WALL-MOUNTCANOPY RANGE HOOD 28 сторінок. 30" and 36" (76.2 and 91.4 cm) wall-mount canopy range hood
Також для Whirlpool 30" AND 36" (76.2 AND 91.4 CM) WALL-MOUNTCANOPY RANGE HOOD: Інструкція з монтажу Посібник з монтажу (28 сторінок)

Друкувати сторінку

2. Measure from the bottom of the air deflector to the bottom

of the hood outlet.

A. Air deflector

B. Vent clamp

C. X = length to cut vent duct

3. Cut the duct to the measured size "X."

4. Remove the air deflector.

5. Slide the duct onto the bottom of the air deflector.

6. Place the assembled air deflector and duct over the exhaust

outlet from the hood.

7. Reassemble the air deflector to the duct cover bracket

with the 4 assembly screws.

8. Seal connections with vent clamps.

Make Electrical Connection

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

1. Disconnect power.

2. Remove terminal box cover.

3. Remove the knockout in the terminal box and install

a UL listed or CSA approved ¹⁄₂" (12.7 mm) strain relief.

D. Vent duct

E. Exhaust outlet

A. Knockout

B. Terminal box cover

C. Terminal box screws (7)

4. Run home power supply cable through strain relief

into terminal box.

A. Home power supply cable

B. UL listed or CSA approved strain relief

C. Black wires

D. UL listed wire connectors

E. White wires

F. Green (or bare) and yellow-green ground wires

G. Terminal box

5. Use UL listed wire connectors and connect black

wires (C) together.

6. Use UL listed wire connectors and connect white

wires (E) together.

WARNING

Electrical Shock Hazard

Electrically ground blower.

Connect ground wire to green and yellow ground wire

in terminal box.

Failure to do so can result in death or electrical shock.

7. Connect green (or bare) ground wire from home power supply

to yellow-green ground wire (F) in terminal box using UL listed

wire connectors.