Whirlpool HE36W Охорона здоров'я та безпека, використання, догляд та інструкція з монтажу - Сторінка 6
Переглянути онлайн або завантажити pdf Охорона здоров'я та безпека, використання, догляд та інструкція з монтажу для Вентиляційна витяжка Whirlpool HE36W. Whirlpool HE36W 16 сторінок.
Друкувати сторінку1. Find a suitable installation position of hood which
should be next to a window and can be cut to let
the exhaust duct pass through.
2. If the exhaust duct has to pass through the wall ,
particular attention must be paid to the structure of
the wall as steel reinforcement may be embedded.
3. Mark the location of exhaust outlet hole, then cut/
drill the hole with care.
4. Fix the position of hood and mark the position of
the two hanging hooks.
5. Drive 2 steel nails into the selected wall with 3 mm
(maximum)space leave behind for hanging the hood.
6. Adjust the hanging hooks on both sides of the hood
and hang the hood on the steel nails, then adjust
the hood from side to side and from front and back
to a horizontal position.
7. Follow the instruction print on the enclosed exhaust
duct adapter and connect the exhaust duct adapter
to the hood and window/wall 5-inch or 6-inch duct
can be used.
8. Fasten the hanging bracket to the wall by screws
from the fixed holes to avoid of being hanged up
by accident.
9. This appliance is not intended for use by persons (including children) with
reduced physical,sensory or mental capabilities,or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsibility for their safety.
10. Children should be supervised to ensure that they do not play with the appliance.
11. Caution To ensure drainage performance, hood shall be installed
with slope (2-4mm) as shown in figure.
Exhaust
duct
3mm(maximum limit)
screw
Wall
Drill a hole for the air tube
Drive 2 steel nails in, on the
upper corner of the both
side of the hood
Adjust the hang hood and
prepare to install
2-4mm