Whirlpool Ventilation Hood Інструкція з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Вентиляційна витяжка Whirlpool Ventilation Hood. Whirlpool Ventilation Hood 7 сторінок. Island canopy range hood
Також для Whirlpool Ventilation Hood: Посібник зі встановлення та використання (32 сторінок)
Друкувати сторінкуMAINTENANCE
IMPORTANT:
GREASE FILTERS
The metal grease filter has an unlimited life and should be cleaned once a month by hand or in a
dishwasher at low temperature and with a short cycle. Cleaning in a dishwasher may cause discolouring
of the grease filter, but its filtering efficiency is unaffected.
Pull out the handle to remove the filter.
Wash the filter and leave it to dry, proceeding in reverse order to refit it.
REPLACING HALOGEN LAMPS
IMPORTANT: Use 20W MAX - G4 halogen lamps only.
1. Disconnect the hood from the household power supply.
2. Use a small screwdriver to gently prise (near the three points indicated) the lamp cover off.
3. Remove the burnt-out lamp and fit a new one.
4. Refit (snap-on) the lamp cover.
ACTIVATED CARBON FILTER
(filter hoods only):
The carbon filter must be cleaned once a month in a dishwasher at the highest temperature,
using a normal dishwasher detergent. It is advisable to clean the filter separately.
After cleaning, reactivate the carbon filter by drying it in the oven at 100°C for 10 minutes.
Change the carbon filter every 3 years.
Fitting the carbon filter:
1. Remove the grease filter.
2. Hook the carbon filter firstly to the metal tab at the back on the hood and then fix it at the
front with the two knobs.
3. Refit the grease filter
- Use protective gloves.
- disconnect the appliance from the power supply.
GB11