Clare Controls ClareHome CS-iMR Інструкція з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Підсилювач Clare Controls ClareHome CS-iMR. Clare Controls ClareHome CS-iMR 6 сторінок. Multi-room audio

Друкувати сторінку

To reduce the risk of fire or electric shock, do not

WARNING:

expose this apparatus to rain or moisture.

Installation

The CS-iMR can be mounted in a structured panel or in a

mounting rack.

Mounting in a panel

When mounting the CS-iMR in a structured panel, you will

need to order and install the ClareHome Structured Enclosure

Extender (P/N CH-EXT-28 or CH-EXT-42) before mounting the

CS-iMR. The Extender provides needed ventilation and

protects against heat build-up.

Remove all contents from the CS-iMR packaging and ensure

that you have the following items.

•

1 CS-iMR device

•

1 North American power cord

•

4 Mounting brackets (for use with structured panel

mounting)

•

8 6-20 × 3/8 in. self-drilling screws (for use with structured

panel mounting, 2 extra screws provided)

Use a power drill to secure the eight 6-20 × 3/8 in.

Note:

screws into the panel.

•

6 4-position Euro-style connectors (use for speakers)

(4 connectors included with the CS-iMR 4-25)

Read all instructions before attempting to install

WARNING:

the equipment. Failure to follow directions can cause bodily

injury and/or damage the equipment.

To mount the CS-iMR in a panel:

Install the ClareHome Structured Enclosure Extender in

accordance with the instructions included in the Extender

kit.

Remove the eight screws from sides of CS-iMR. See

Figure 1.

Using the same screws, attach the four mounting brackets

to the sides of the CS-iMR.

Place the CS-iMR in the structured panel 3.5 in. (8.9 cm)

from the top of the panel box to ensure the plug fits

properly. See Figure 2.

Attach the CS-iMR to the panel box by using a power drill

to drive four of the 6-20 × 3/8 in. self-drilling screws though

the bracket holes and into the back of the panel brackets.

See Figure 2.

Ensure the holes in the brackets on the sides of the

Note:

CS-iMR do not line up with the holes in the back of the

panel box so you have a solid surface to attach to the

brackets. Also, be sure to place each 6-20 × 3/8 in.

self-drilling screw in the center of the bracket hole.

2 / 6

Figure 1: Caption for the product ID figure

Figure 2: Caption for the product ID figure

3.5 in.

(8.9 cm)

Doc ID - 1307 • REV 02