Backyard Pro Butcher Series Інструкція з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Комерційне харчове обладнання Backyard Pro Butcher Series. Backyard Pro Butcher Series 11 сторінок. Meat tenderizer motor
Також для Backyard Pro Butcher Series: Інструкція з експлуатації (5 сторінок), Інструкція з експлуатації (5 сторінок), Інструкція з експлуатації (7 сторінок), Інструкція з експлуатації (11 сторінок), Інструкція з експлуатації (6 сторінок), Інструкція з експлуатації (6 сторінок), Інструкція з експлуатації (5 сторінок), Інструкція з експлуатації (4 сторінок), Інструкція з експлуатації (8 сторінок), Інструкція з експлуатації (4 сторінок)

General Information and Instructions

GRINDING INSTRUCTIONS

• For best results, trim all excess tendons, and skin then remove the meat from bones.

• Optimal results occur when meat is chilled to 32-34˚F before grinding.

• Cut meat into pieces that will easily fit in throat of grinder head. (Approximately 1 inch squares.)

• Place cubed meat into tray. Be sure not to over fill the tray. Make sure the throat opening of the

tray remains clear and open.

• Place a dish, bowl or tray under grinder head to catch ground meat.

• Switch grinder to "FOR" position or "I" position ("I" means on for #8 & #12 meat grinders, "FOR"

means on for #22 & #32 meat grinders). Carefully begin to feed meat down the throat. Use the

plunger to push meat. DO NOT use fingers or utensils other than the plunger provided; bodily injury

may occur and you could damage your grinder.

IF JAMMING OCCURS OR PERFORMANCE SLOWS

First turn the switch to "REV" position ("REV" means reverse) and press for 3-5 seconds. Then turn the

switch to ""FOR" position for grinding. If performance still continues working slowly, please follow the

steps as below. ("REV" is only for #22 & #32 meat grinders)

• Shut grinder off immediately.

• Remove power cord from outlet.

• Carefully remove grinder head ring cap, grinder plate, and cutting blade.

• Carefully clean grinder plate holes thoroughly and remove any tendons from around the

cutting blade.

• Replace the cutting blade, grinder plate, and screw ring cap back onto the grinder head.

• Continue grinding.

• Repeat these steps as necessary to enhance grinder performance.

After turning the switch from "FOR" position to "OFF" position, please wait

until the motor stops completely. Then turn the switch to "REV" position. Also,

please wait until the motor stops completely when turning the switch from

"REV" position to "OFF" position.

Then turn the switch to "FOR" position. Otherwise, the motor will be damaged.

SAUSAGE STUFFING ASSEMBLY

• Be sure the grinder is unplugged.

• Attach grinder head to motor and install auger as previously described in General Assembly

instructions.

• Slide the stuffing plate onto auger. The grinding blade is not used when stuffing.

• Slide one of the stuffing tubes through the funnel flange and place in the grinder ring cap (stuffing

tube faces out). The stuffing tube size used depends on the type of casing you have chosen to use.

(See Fig 7)

• Firmly screw the grinder ring onto the grinder head. (See Fig 8)

CAUTION