Firestar vi30 Посібники з швидкого старту - Сторінка 14

Переглянути онлайн або завантажити pdf Посібники з швидкого старту для Вимірювальні прилади Firestar vi30. Firestar vi30 15 сторінок. Dual cooled laser

Друкувати сторінку

Firestar™ vi30/40 Dual Cooled Laser Quick Start Guide

Initial Start up without a UC-2000 Controller (Continued):

21.

Restore power to the laser and turn on the +48 VDC power supply. Turn on the +48 VDC power

supply. The laser's PWR LED should illuminate green. After a five-second delay, lasing is enabled

when a PWM Command signal is received.

22.

Set your PWM controller to a frequency of 5 kHz (at a +5 volt level) and ensure that the controller's

duty cycle is set to zero percent output (0.0%).

23.

Apply a Laser Enable signal to the DB-9 I/O connector. The yellow RDY lamp turns on to indicate

that, after a five-second delay, lasing is enabled when a PWM Command signal is received. Lase

LED will illumate red.

24.

If your laser fails to lase, reference the laser's Troubleshooting Section within the Operation Manual,

SYNRAD website for more information or contact SYNRAD support.

Pin 5

Pin 9

READY

LED.

Pin 1

Pin 6

POWER LED.

vi30/40 Dual Cooled QSG Version 2.1

LASE LED.